New Equipment | Test Equipment
The ADA400A Differential Preamplifier allows direct oscilloscope measurements of very low amplitude voltages and signals which are not ground referenced. The high impedance of both inputs eliminates the need to add additional ground points in the DUT
New Equipment | Test Equipment
Agilent high performance DC power supplies offer speed and accuracy for test optimization. The single output, 2000W 6571A-6575A provide front panel and analog control of output voltage and current; fast, low-noise outputs; fan-speed control to minimi
Used SMT Equipment | In-Circuit Testers
Agilent U2001H Key Specifications -Frequency range of 10 MHz to 6 GHz -Wide dynamic range (-50 dBm to +30 dBm) -Internal zeroing while connected to the DUT -High measurement speed of up to 250readings/second -Display power measurements on a
Used SMT Equipment | In-Circuit Testers
Agilent-Keysight 4339B High-Resistance Meter, DC The 4339B high-resistance meter is Agilent Technologies' most advanced tool for making precision high-resistance measurements. The test sequence program function provides an automatic measurement
Industry News | 2008-03-04 12:22:45.0
Agilent Technologies Inc. (NYSE: A) today announced the latest release of its firmware for the Agilent N6705A DC Power Analyzer, which incorporates more than 25 customer-recommended enhancements.
Industry News | 2008-06-03 15:24:25.0
Agilent Technologies Inc. (NYSE: A) today announced nonlinear vector network analyzer (NVNA) capability for its PNA-X microwave network analyzer, establishing a new industry standard in RF nonlinear network analysis from 10 MHz to 26.5 GHz.
Parts & Supplies | Hand Assembly
VG Mass Interconnect is a series of modular fixture products that allows quick connection between the UUT (unit under test) and a custom test system. VG mass interconnect is divided into 2 segments: Receivers (Tester Side), and Fixture Kits (DUT
Technical Library | 2016-02-04 19:11:47.0
In a typical mechatronic manufacturing functional test setup, actual load simulations are usually done by connecting the DUT outputs to power or ground in order to establish either a high or low side driver. Each output is connected with different load and the test will either be sequential or concurrent. At lower power levels, these can usually be managed with general purpose switches. However, when it comes to higher power levels of currents more than 5 amps, such switching and loading might pose a greater challenge. Furthermore, critically in the manufacturing line, the tradeoff between cost and test time would have a great influence on the test strategy.This paper will present some key points to design a cost effective high power switching and load management solution.
ALL-IN-ONE: JOT G3 Final Tester. It enables fully automated tests of mechanical, RF, electrical, audio, and visual interfaces.
Article Return to Front Page Key Drivers Of Custome
