Electronics Forum | Wed May 12 08:16:33 EDT 2004 | solderpro
woow, slow down hot rod, hey davef, you are alright by me, good to see some one out there that has hands on experience rather than a theory nut.... any how, you need a top of the line profiler, super gold mole, or Kic.... these truly are the best and
Electronics Forum | Mon Jan 04 22:59:23 EST 1999 | Kris Ewen
I'd like to add something about the ECD product. During a past work term (I'm a a co-op student) in an SMA plant, I worked extensively with the Super MOLE Gold in developing the reflow profiles for high-mix, low-volume production. I was 'married' t
Electronics Forum | Mon Jan 28 15:34:19 EST 2008 | slthomas
I have used the ECD MOLE and had no complaints. I also checked out a Datapaq at one time and really liked the software but it was a little on the spendy side. ECD provides free upgrades to their software which does provide some fairly helpful pred
Electronics Forum | Thu Aug 30 13:22:47 EDT 2001 | arzu
180deg More important are the preheat and soakzones and temp ramps. How to check: I used to do it as follows: use a TEST-PCB with fixed thermocouples and connect it to the mole. Print the profile on transparant paper. do it again e.g. each week and
Electronics Forum | Fri Mar 05 12:25:02 EST 2010 | leemeyer
Hi all I have an opportunity to purchase a lightly used Super M.O.L.E Gold profiler along with the Auto Mole Xpert oven setup package. Can I get some opinions on how well the predictor and oven setup works. Also is the software user friendly? I would
Electronics Forum | Tue Aug 12 18:37:54 EDT 2008 | shanenaturalpoint
Does anyone out there have experience reflow profiling with a Heller 1500SX? At my past places of business, I had an ECD Super MOLE, and I got pretty reliant on it. Need some help getting to where I need to go with this software. Thanks in advance
Electronics Forum | Thu Aug 11 20:12:12 EDT 2016 | davef
Different points on the board couple have different thermal masses. Look here: http://www.ecd.com/portals/5/products/vmole/V-MOLE-Verify-3-Thermocouple.pdf
Electronics Forum | Mon Jan 04 11:32:59 EST 1999 | Chrys
| Anyone have any experience with ECD's Waverider/MOLE profiling equipment? If so, were they positive experiences? | I use ECD's mole for profiling in the wave and a KIC for profiling in reflow. I like the KIC a whole lot better for a couple of re
Electronics Forum | Wed Sep 22 15:01:05 EDT 2004 | Hayden
Thank you for the help
Electronics Forum | Thu Mar 02 17:32:09 EST 2006 | sphilips
The initial cost of the battery is similar to saying the size of an iceberg is measured only by what shows above the waterline. There is a lot more to it than at first blush. The ECD Power Pack costs $245, but provides over 3500 hours of profiling.