Electronics Forum | Thu Aug 30 13:22:47 EDT 2001 | arzu
180deg More important are the preheat and soakzones and temp ramps. How to check: I used to do it as follows: use a TEST-PCB with fixed thermocouples and connect it to the mole. Print the profile on transparant paper. do it again e.g. each week and
Electronics Forum | Wed Aug 14 12:24:59 EDT 2013 | action_101
Thats nice sfeinsp. I have also used several of ECD's products including the Super Mole Gold and the V-mole and they are fine products. My question was is anybody using the ECD OvenChecker system and what are your thoughts on the product.
Electronics Forum | Tue Aug 12 18:37:54 EDT 2008 | shanenaturalpoint
Does anyone out there have experience reflow profiling with a Heller 1500SX? At my past places of business, I had an ECD Super MOLE, and I got pretty reliant on it. Need some help getting to where I need to go with this software. Thanks in advance
Electronics Forum | Mon Jul 28 14:30:22 EDT 2008 | grics
Take a look at this. Remember, these are only guidlines and can not replace any paste specs. As Real Chunks said, a profiler will be of HUGE help. We use this to determine what our top side temps are and to see if we have any problems with heat sen
Electronics Forum | Thu Jun 01 17:24:48 EDT 2006 | flipit
Hi, I spoke to Kic about this at the Apex show in Feb. They told me it was OK to use the Orange Monkey Fur box for lead free. I even asked about my old side kic and they said it was OK also. I guess it depends on how high your temps are. I agree
Electronics Forum | Fri Apr 18 14:44:56 EDT 2008 | jax
Saunders Technology... or ECD (makers of M.O.L.E.) has what is called a TEMPROBE that will work how you want... even in "wet" solder paste. Maybe others here can tell you if it works well or not, I use KIC. www.ECD.com/saunders/tp.htm
Electronics Forum | Thu Aug 02 12:43:14 EDT 2001 | nwyatt
Wave rider is an oven profiler made by ECD. http://www.ecd.com. They are commonly known for their MOLE. The wave rider is different from the MOLE because it is used to measure the temperature, conveyor speed, etc. of the OVEN instead of the pcb.
Electronics Forum | Fri May 02 11:11:49 EDT 2008 | lon_sanders
The cable required for the Thinline has to work as a true RS232 interface as the unit uses all the capabilities of RS232. You will have several problems with substitutes. These cables (part number e00-2787-26) are still avaliable from ECD, the home o
Electronics Forum | Thu Aug 11 20:12:12 EDT 2016 | davef
Different points on the board couple have different thermal masses. Look here: http://www.ecd.com/portals/5/products/vmole/V-MOLE-Verify-3-Thermocouple.pdf
Electronics Forum | Wed Sep 22 12:23:11 EDT 2004 | Peter Barton
FYI Label on the back of my charger says the following: Pt. No. WD23D200KCN PSU E31-0900-21 Input 230 V AC Output 9V DC, 0.2A 1.8VA Ours is of course United Kingdom type, even if the mains plug is European and requires an adaptor. Not too sure a
