Electronics Forum | Fri May 02 11:11:49 EDT 2008 | lon_sanders
The cable required for the Thinline has to work as a true RS232 interface as the unit uses all the capabilities of RS232. You will have several problems with substitutes. These cables (part number e00-2787-26) are still avaliable from ECD, the home o
Electronics Forum | Thu Aug 11 20:12:12 EDT 2016 | davef
Different points on the board couple have different thermal masses. Look here: http://www.ecd.com/portals/5/products/vmole/V-MOLE-Verify-3-Thermocouple.pdf
Electronics Forum | Wed Sep 22 12:23:11 EDT 2004 | Peter Barton
FYI Label on the back of my charger says the following: Pt. No. WD23D200KCN PSU E31-0900-21 Input 230 V AC Output 9V DC, 0.2A 1.8VA Ours is of course United Kingdom type, even if the mains plug is European and requires an adaptor. Not too sure a
Electronics Forum | Wed Nov 25 21:23:29 EST 1998 | Dave F
| I like to know under what conditions the reflow profile of a solder paste is taken? Bare board, board with the solder paste, or board with high melt solder paste? | John: None of the above. The two key variables that determine the reflow tempera
Electronics Forum | Tue Feb 19 09:41:26 EST 2008 | slthomas
ECD sells the MOLE, and they sell both the Oven Rider and the Wave Rider to accompany it. The thing is, you can profile both an oven and a wave machine without either if you're willing to just solder your thermocouples to a board. The nice thing ab
Electronics Forum | Mon Jan 04 11:32:59 EST 1999 | Chrys
| Anyone have any experience with ECD's Waverider/MOLE profiling equipment? If so, were they positive experiences? | I use ECD's mole for profiling in the wave and a KIC for profiling in reflow. I like the KIC a whole lot better for a couple of re
Electronics Forum | Mon Jan 04 22:59:23 EST 1999 | Kris Ewen
I'd like to add something about the ECD product. During a past work term (I'm a a co-op student) in an SMA plant, I worked extensively with the Super MOLE Gold in developing the reflow profiles for high-mix, low-volume production. I was 'married' t
Electronics Forum | Fri Mar 19 07:24:29 EST 2004 | pjc
Before "Pb-Free" became an issue we were and still are using Pb-Free component lead finishes- such as on many TSOP, SSOP and QFP packages as well as caps. Components manufacturers changing the lead finish to no-Pb tend to ensure solderability with Sn
Electronics Forum | Wed Sep 05 14:51:47 EDT 2001 | gdstanton
Well, it appears after running both a bare and populated PWB we were seeing flux exhaustion on the uBGA. The problem apparently resulted by a recent maintenance effort where the air blowers in the reflow oven were replaced. The blower replacement m
Electronics Forum | Fri Jun 02 12:18:47 EDT 2006 | Vince Whipple
Marc, Topside temperature is one of the most critical parameters for a successful solder process. Temp stickers are OK to use but won�t tell you the temperature in tight areas. The temp gun like Jay suggested is what I use as a quick indicator. (Rayt