Electronics Forum | Sun Apr 10 03:25:35 EDT 2005 | Peter
Normally, some conformal coatings do not have very good wetting properties, that should be basic function of a good coating material (the same reqirement as avoid bubbles during coating process)! For UV curing conformal coatings, you can try Lackwe
Electronics Forum | Thu Jun 28 10:46:44 EDT 2001 | genny
Thank you. I'm sorry if I came across frustrated or anything, but I wasn't sure if people were ignoring the one question I kept asking or if, as you said, they just didn't know. Here's the deal. We are a small company rapidly growing into a larger
Electronics Forum | Sat Jun 30 11:28:24 EDT 2001 | davef
Consider using a roll solder with a flux that well matches the residues you can accept to be remaining on the board when you get finished processing. Many people use a no-clean flux cored roll solder for such operations, because they don't want to c
Electronics Forum | Fri Jan 15 09:11:28 EST 1999 | Steve Gregory
| Due to an foul up on my part, a circuit board ECO snuck up on me and I have a solder paste stencil that doesn't quite match the board. Two pads are off by about half a pad each. | | Can the solder paste stencil be modified? If so, what is the tec
Electronics Forum | Wed Sep 23 20:42:10 EDT 1998 | Steve Gregory
Boy Chrys, aren't you lucky? Too busy to mess with that stuff huh?...must be nice!! Ya' know, it doesn't say much for the design, or the design-er when you see a bunch of wires on board, but if the person who does the jumper wires is good, and take