Electronics Forum | Tue Nov 28 14:02:06 EST 2006 | jsloot
I am starting to use a DATAPAQ wave analysis software on our Econopak EPK II machines. I would like to know what values you may be using for alarm conditions. I can email an example if you can help. Thanks
Electronics Forum | Thu Feb 13 08:28:47 EST 2003 | pjc
Call 1-800-737-8110 for tech support. They can give you the N2 supply specs for the 650C. You should consider the cost to convert the Contour to a standard Lambda vs. the cost to bring in N2 and the consumable costs. Tech Support can give you the ret
Electronics Forum | Mon May 19 10:35:58 EDT 2008 | samir
I agree with RealChunks. The application of any of these "wave solder process control tools" is dependant on how the shop is run. At some shops, PM is inconsistent and slacked off on. At other shops, there is no technical expertise at the operator
Electronics Forum | Fri Jun 12 14:22:53 EDT 1998 | Ryan Jennens
| Hey all! | The wave solder warrior is back. I have found a flux which leave almost no residue (the least yet), but because of its super low solids content I absolutely cannot get topside fillets. The multi-layer, two sided board is on a pall
Electronics Forum | Fri Jun 12 14:31:04 EDT 1998 | Earl Moon
| | Hey all! | | The wave solder warrior is back. I have found a flux which leave almost no residue (the least yet), but because of its super low solids content I absolutely cannot get topside fillets. The multi-layer, two sided board is on a
Electronics Forum | Fri Jun 12 15:56:43 EDT 1998 | Ryan
| | | Hey all! | | | The wave solder warrior is back. I have found a flux which leave almost no residue (the least yet), but because of its super low solids content I absolutely cannot get topside fillets. The multi-layer, two sided board is o
Electronics Forum | Wed Jan 11 16:56:15 EST 2006 | russ
So are you saying that you cannot reach 110C at 1 location without raising another location to excessive preheat temp? If so, sometimes slowing down the conveyor and dropping the preheat temps will help you get equal temps. I do not know this machi
Electronics Forum | Tue May 07 10:32:13 EDT 2002 | Todd M. Troyer
Does any one know where I can get after-market preheaters for an Electrovert Econopak II SMT wave?
Electronics Forum | Mon Jan 13 18:21:54 EST 2014 | vwhipple
A little confusion here. Are you running several boards in one pallet and the last boards are looking poor or is the issue getting worse as the day progresses (like as the pallets get warm)? - If it is the last boards in the pallet, then you may wan
Electronics Forum | Tue Dec 16 06:42:51 EST 2003 | Kev
I am having problems achieving correct pre-heater temperatures with our Hollis solder wave. Our original "Verification Golden board" program uses a conveyor speed of 5ft per minute and pre-heat temps of 300, 350, 400 respectively. Our "golden Board"
