Electronics Forum | Mon May 19 10:35:58 EDT 2008 | samir
I agree with RealChunks. The application of any of these "wave solder process control tools" is dependant on how the shop is run. At some shops, PM is inconsistent and slacked off on. At other shops, there is no technical expertise at the operator
Electronics Forum | Tue May 07 10:32:13 EDT 2002 | Todd M. Troyer
Does any one know where I can get after-market preheaters for an Electrovert Econopak II SMT wave?
Electronics Forum | Tue Jan 10 11:34:11 EST 2017 | charliedci
Have you contacted Speedline? They took over the Electrovert products and have provided us with parts and support on our 25 year old Econopak +.
Electronics Forum | Thu Nov 16 12:52:04 EST 2017 | charliedci
We installed a SonoFlux ultrasonic spray fluxer, replacing the foam fluxer in our Electrovert Econopak wave in 2014. The cost at that time was 16K, installation included. We ran water based flux through it and as long as we kept it clean, worked well
Electronics Forum | Tue Jun 25 22:22:22 EDT 2019 | proy
We have an electrovert 16" econopak wave solder machine with two identical pots (exchange between Tin Lead and Lead Free). When the pots are exchanged the same thermocouple is used, and the same controller is used - with the set point adjusted. The S
Electronics Forum | Wed Jul 10 22:13:45 EDT 2019 | SMTA-Ray
I don't recall if the heater wattage is the same or not for the different pots. If the wattage is different then the PID algorithm is also different. this anticipated when & by how much the heater will overshoot its setpoint and turns the heater off
Electronics Forum | Tue Jan 20 21:37:26 EST 2004 | alwil
I am looking for a supplier or a manufacturer who can help me with Titanium Fingers for our Electrovert Econopak Plus wave solder. I am looking for the "v" groove type and also the 90 degree type fingers. I am in Australia. Thanks.
Electronics Forum | Mon Feb 28 11:24:13 EST 2005 | EHess
Still looking for a second source for the Electrovert Econopak II wave solder pump motors, or a place that rebuilds them. anyone? Anyone? Beuhler?
Electronics Forum | Thu Nov 05 10:09:36 EST 2009 | soudomphong
Hi guys, I am looking for a processor board for econopak plus wave solder. Teknor microsystems (TEK234). Please email me if you have or know who has it. Thanks.
Electronics Forum | Tue Jan 17 06:45:29 EST 2006 | meritajs
Hi All, Could somebody help us to acguire manual or technical info for solder wave Electrovert Econopak and reflow oven HELLER 1500S Thank you Peter
