Electronics Forum | Thu Sep 26 12:53:56 EDT 2013 | markhoch
I'm not sure where you're located, but you should try contacting your Regional Sales Rep for ECD or KIC Thermal. They often times have demo units that they are required to "demo" several times per year. They may be willing to come in and profile your
Electronics Forum | Thu Sep 26 18:33:59 EDT 2013 | mballen
Hello Derek, Many new ovens do not have the TC connections for use with trailing wires any longer. As "A Very Frazzled Man" said there are several types of profilers available at varying prices, depending on your requirements. I would be happy to s
Electronics Forum | Thu Mar 23 09:29:58 EST 2006 | Joe
I agree that it's the probably the chain. The links get dirty and can bind up over time. When you pull the chain, check to see that each link rotatates freely with its adjacent link. I bet you'll find one or more links that are binding. This is the s
Electronics Forum | Mon Mar 20 09:08:42 EST 2006 | mapell
AR Sounds like dirty chains... couple ways to check... Pull off the drive chain for the conveyor. Place a wrench on the (unload end) drive shaft and spin, if it is a bit tough.. dirty rails. Also look at load end of chains. The chain goes low and w
Electronics Forum | Thu Jul 11 09:14:16 EDT 2013 | dontfeedphils
Not sure if this will help or not, but I attached a couple of files that I had laying around.
Electronics Forum | Fri Mar 22 10:40:51 EDT 2013 | derekj
Hello all. I was hoping that maybe someone has a manual for a Omniflo 5. Build year is 1998. Photocopies would be greatly appreciated, and willing to pay. Even if we could put down a deposit, you send the manual we do the photocopy and we can send it
Electronics Forum | Wed Jul 10 19:17:06 EDT 2013 | m20lara
Hello all. I was hoping that maybe someone has a > manual for a Omniflo 5. Build year is 1998. > Photocopies would be greatly appreciated, and > willing to pay. Even if we could put down a > deposit, you send the manual we do the photocopy > and
Electronics Forum | Tue Sep 02 13:35:29 EDT 2008 | evtimov
Hi, I don;t thing there is an overtemperrature sensor. Just the thermocpouple returns a higher temp(voltage) to the controller and your software goes to alarm, cooldown or what ever it does. Emil
Electronics Forum | Thu Sep 04 02:43:09 EDT 2008 | benefon
Thanks This error only occurred with one oven profile with the reflow zone temperature set at 270�C. Perhaps it really has to do with the exhaust pull as the oven is operating very near its temperature limit with this profile. I will check that. Tha
Electronics Forum | Wed Sep 03 07:39:19 EDT 2008 | pjc
You may not be getting enough exhaust pull, so the cooling modules over temp. Try swapping blower motors to isolate that before buying one. STANDARD AIR OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unlo
