Electronics Forum | Thu Aug 20 14:46:26 EDT 2020 | goldendragon
Yes, it's autowidth oven. I thought about manually adjust both end to match with the with the middle. Thank you very much! Tim
Electronics Forum | Thu May 27 13:18:30 EDT 2004 | swilson
Hello does anyone have a schematic or service manual on setting up a foam fluxer on the 650C wavesolder machine. I am concerned with the two pumps in the rear of the machine what are the connection for on the pumps. I do have the manuals, but they do
Career Center | ORLANDO, Florida USA | Engineering,Maintenance,Production,Technical Support
Manufacturing tech/eng for a contract manufacture for 10+ years. Been working in the SMT industry for a total of 20yrs. Have done everything from operator to process work. Most familiar with Assembleon, MPM, DEK, BTU,Electrovert, SLIM-KIC, SUPER-MOLE
Electronics Forum | Thu May 31 18:21:09 EDT 2007 | jamesm
Revelation Industries has an Electrovert MPK1-24774. The manual lacks sufficient information to troubleshoot and fix this problem: Reference: Minipack 300 Wavesoldering System 1986 edition, pg, 18, fluxer, Threshold adjustment. After completin
Electronics Forum | Thu Jul 17 11:34:35 EDT 2003 | pjc
� Center board support: - Stationary tension wire - Adjustable width and height position (manual) - Pneumatic raise/lower feature; extends through preheat and solder wave - Minimum board clearance on bottom preheater #1 is 63.5 mm (2.5 in.) with
Electronics Forum | Mon Jun 27 15:02:55 EDT 2005 | cmiller
Thanks for the reply. I had the instructions out of the manual but after re-programming we had all kinds of wierd stuff going on. After re-setting the PC several times it worked fine. Can I get a copy of the instructions you have? It would be appreci
Electronics Forum | Thu Jan 31 11:49:21 EST 2002 | MikeF
Does anyone out there have a wave solder troubleshooting chart in electronic form they could e-mail me? I'm about to crank up a wave solder machine here, and the chart I got several jobs ago is missing in action. Also, if anyone remembers using a
Electronics Forum | Mon Jun 13 11:48:33 EDT 2005 | CMiller
We got a F04 error (internal Memory fault) on the shared drive and entered 8 in location N001 as per the maint manual and cycled the power. I then set all the locations listed in the manual to thier default settings. Now the motors do not run to thei
Electronics Forum | Mon Jan 23 14:20:32 EST 2006 | gipos
Hi Chunks, Thank you very much for your advise.It is realy helpfull.Seven years of experience are the most precious. But we have already payed the Universal Full IR.We can use it for curring of glue and paint.Do you know where we can find user or se
Electronics Forum | Mon Aug 10 21:11:00 EDT 1998 | Dave F
| Good day. We have just purchased a HOLLIS POLYCLEAN SMT Machine. We did not receive a manual and for installing the machine, we need the indications for the ventillation system: ie the number of CFM for the blower. | We would greatly appreciate i
.gif)
