Electronics Forum | Fri Dec 18 12:14:10 EST 1998 | Brian Steelglove
| | Does anyone out there have one we are currently looking at one from a used equipment dealer and would like to know how they work? Good or bad for SMT? | | Good or bad for high volume Thrue Hole? | | | | Thanks Again, | | Brian Steelglove | | A
Electronics Forum | Mon Dec 21 08:49:29 EST 1998 | Aric Parr
I used one on SMT at a previous employer. Make sure that you have 3 zones of preheat. Make sure that your operators are trained. The airknifes are extremely difficult to set up properly. Don't use them on high mix lines. We didn't need them once
Used SMT Equipment | Board Cleaners
Electrovert Aquastorm 200 Board Wash;1; Vintage: 10/2000; 440 VAC 3-Phase 122KVA; Top & Bottom 20in. Mesh Belt; Hurricane Option; Three Drying Sections; External Rinse Sink; 10HP Wash & Rinse Pumps; (2) 15HP & (1) 10HP Dryer Blowers
Used SMT Equipment | Soldering - Wave
Speedline / Electrovert Electra Wave Solder System; 11/2007 Vintage; 20in Process Width, 208 volt, VVL Fingers, Exit Cooling Fans, 3 Bottom Convection Preheater, 2 Top IR, Heater; Servojet Spray Fluxer;Ffull N2; N2 Short Tunnel Option; Titanium Main