Electronics Forum | Mon Feb 28 11:24:13 EST 2005 | EHess
Still looking for a second source for the Electrovert Econopak II wave solder pump motors, or a place that rebuilds them. anyone? Anyone? Beuhler?
Electronics Forum | Wed Jan 26 16:51:18 EST 2000 | Casimir Budzinski
I am using kester 958 no clean in an Electrovert Econopak 2 and having trouble with white residue, the solder pot has a foam fluxer and I have tried diferent setings on the air knife angle & pressure, the top board temp is aprox 200F.Any help would b
Electronics Forum | Tue Jan 20 21:37:26 EST 2004 | alwil
I am looking for a supplier or a manufacturer who can help me with Titanium Fingers for our Electrovert Econopak Plus wave solder. I am looking for the "v" groove type and also the 90 degree type fingers. I am in Australia. Thanks.
Electronics Forum | Mon Jul 05 03:14:47 EDT 2004 | P.V
I am looking for the solder pot size on the above wave machine, any help would be appreciated
Electronics Forum | Tue Feb 08 07:11:24 EST 2005 | teilo
We manufacture all titanium component parts for wave solder machines. For additional information on our products please visit our websit at http://www.teiloengineering.com
Electronics Forum | Tue Jan 17 10:00:19 EST 2006 | alandra516
Contact me I have both mauals that you need glenn@alandraservices.com
Electronics Forum | Tue Jan 17 10:09:03 EST 2006 | pjc
I will send an engineering data sheet to your e-mail address. I do not have a manual, check with these guys: Tom or Dennis (603) 437-4755 Ed Fortuna (603) 759-2953
Electronics Forum | Wed Jan 18 02:08:11 EST 2006 | meritajs
Dear Pete C, If it is possible please send this engenering sheets to us e-mail:altonteh@tl.lv Thank you and best regards Peter
Electronics Forum | Thu Jan 11 12:42:55 EST 2024 | richardcargill
if the battery failed then you will have lost all the Cmos settings it held relating to the disk drive configuration/availability. Jump into the PC setup at switch on and make sure everything is correct
Electronics Forum | Mon Dec 12 13:34:15 EST 2005 | jbrower
Hi Frank I use an electrovert econopak and am very pleased with it. Electrovert offers a leadfree upgrade to the pot but it is a might bit expensive. Contact them for pricing. In my machine I am going with SN100 distributed by AIM. It might be some
.png)
