Electronics Forum | Fri Jan 24 09:26:29 EST 2003 | pjc
I sent you a couple of charts to assist with your troubleshooting. One is the Electrovert Wave Solder Troubleshooting chart and the other is Sandia Labs/Electrovert Optimum Solder Contact Time. Electrovert has a 6 deg. conveyor angle standard on the
Electronics Forum | Wed Dec 14 10:08:44 EST 2005 | slthomas
I am sort of familiar with Specnor Tecnic myself from work at a previous employer. Yes, they are a group that split of from Electrovert and actually compete with Electrovert in their spares market. Don't know how that's legal but they seem to be doin
Electronics Forum | Fri Dec 18 12:14:10 EST 1998 | Brian Steelglove
| | Does anyone out there have one we are currently looking at one from a used equipment dealer and would like to know how they work? Good or bad for SMT? | | Good or bad for high volume Thrue Hole? | | | | Thanks Again, | | Brian Steelglove | | A
Electronics Forum | Fri Dec 18 10:00:19 EST 1998 | Chrys
| Does anyone out there have one we are currently looking at one from a used equipment dealer and would like to know how they work? Good or bad for SMT? | Good or bad for high volume Thrue Hole? | | Thanks Again, | Brian Steelglove | American Prec
Electronics Forum | Mon Dec 21 08:49:29 EST 1998 | Aric Parr
I used one on SMT at a previous employer. Make sure that you have 3 zones of preheat. Make sure that your operators are trained. The airknifes are extremely difficult to set up properly. Don't use them on high mix lines. We didn't need them once
Electronics Forum | Tue Dec 22 10:00:31 EST 1998 | Chrys
| | | Does anyone out there have one we are currently looking at one from a used equipment dealer and would like to know how they work? Good or bad for SMT? | | | Good or bad for high volume Thrue Hole? | | | | | | Thanks Again, | | | Brian Steelg
.png)
