Electronics Forum | Tue Mar 20 04:40:15 EDT 2018 | rob
I've seen them down at 2 metres in the past, but usually only 4 zone. from memory Electrovert used to do a small 5 zone with pin chain - Infraflow 500 or something. To be fair, even small one line CEMs usually have a decent oven as you need to be a
Electronics Forum | Thu Oct 08 22:32:53 EDT 1998 | E.
*Reply to: ericr@nj.tanon.com Without going into a lengthy explaination {at this time}, has anyone experimented, tested, evaluate, and/or 'perfected' an SMT double-side reflow process. Presently I'm using a Kester R593 OA (water soluble) Sn63/Pb37 -
Electronics Forum | Thu Oct 13 15:41:30 EDT 2005 | lyrtech
Hi, We have a customer who give us a 20K board contract each year. It's only thru-hole components.The baord is HASL plated. So we pass it into our wave. No problems. Recently, our customer decided to go into GOLD PLATED finish. We take the same re
Electronics Forum | Fri Jan 21 19:10:49 EST 2005 | fastek
Allow me to re-state my response. Hours on an oven would be the last thing I would care about if I wanted to know something about it. There is no standard lifespan on heaters, blowers and the like. They can last a year or ten. Sure you can assume a 5
Electronics Forum | Sat Oct 10 04:58:18 EDT 1998 | Tony B
| *Reply to: ericr@nj.tanon.com | | Without going into a lengthy explaination {at this time}, has anyone experimented, tested, evaluate, and/or 'perfected' an SMT double-side reflow process. Presently I'm using a Kester R593 OA (water soluble) Sn63/
Electronics Forum | Fri Aug 20 09:33:51 EDT 1999 | Don Morgenstern
Earl & Jeff Our machine is different than the Electrovert Solder Pak in that it is does not behave like a "volcano". Jeff, please contact me if you have safety concerns as perhaps you also want to consider our equipment. | | I'm trying a second ti
Electronics Forum | Thu Aug 19 22:59:48 EDT 1999 | Jeff Ferry
| I'm trying a second time to post this very important message, to me, concerning Air-Vac's following creation. Does any own and use this stuff successfully to remove solder from 20 layer and up MLB's with .020" diameter holes? Also, is any of the ad
Electronics Forum | Thu Aug 19 23:56:49 EDT 1999 | Earl Moon
| | I'm trying a second time to post this very important message, to me, concerning Air-Vac's following creation. Does any own and use this stuff successfully to remove solder from 20 layer and up MLB's with .020" diameter holes? Also, is any of the
Career Center | ORLANDO, Florida USA | Engineering,Maintenance,Production,Technical Support
Manufacturing tech/eng for a contract manufacture for 10+ years. Been working in the SMT industry for a total of 20yrs. Have done everything from operator to process work. Most familiar with Assembleon, MPM, DEK, BTU,Electrovert, SLIM-KIC, SUPER-MOLE
