Electronics Forum | Fri Apr 16 15:12:12 EDT 2021 | jsmith01
Does anyone know where the power to the lambda, chip sensors comes from on a Electrovert EPK plus? I have an intermediate issue with these sensors loosing power and the wave just keeps going higher and flows over the pot. I have replaced the senors
Electronics Forum | Mon Jul 16 15:10:53 EDT 2018 | charliedci
I have install and program disk for Electrovert EPK +400. Contact me at charlie.magill@elecsyscorp.com
Electronics Forum | Mon Feb 28 10:11:27 EST 2005 | jbrower
Hi Ing, My suggestion is to take a good look at your profile(s). The Wave solder machine that I use is an Electrovert EPK I. I use Aim ultra pure 63/37 solder with an older kester flux, 920CFX. I recently switched from kester ultrapure to the aim ba
Electronics Forum | Sat Jan 14 18:07:15 EST 2006 | Sona
I am looking for someone on the East Cost to service the following equipment. Electrovert EPK and DEK 260. We need to also add some convection heaters on the wave machine. We are located outside Philly, Pa If anyone can provide me with this info I a
Electronics Forum | Thu Nov 25 17:32:54 EST 2010 | padawanlinuxero
Hello !!! Long time since I was here, I have a problem, I use a Electrovert EPK Plus solder wave to solder 8 leads the pcb is like a inche wide and 3/4 or less of height and the leads their size is .3570 inches long by .0195 wide and .0180inches th
Electronics Forum | Tue Mar 11 18:01:26 EST 2003 | russ
Tim, I cannot remember what model our T.D. wave was it was a small unit about 8 ft. long "tabletop" is what I call them. In keeping up with this thread I noticed a lot of T.D. support. So, I decided to backtrack and review history with my previous pe
Career Center | Bangalore-560026, Karnataka India | Engineering,Maintenance,Technical Support
New Product Introduction & Product dovelopment