Industry News | 2020-08-28 03:07:38.0
ITW EAE is proud to announce that it has earned two Vision Awards for innovative MPM and Electrovert technology developments. MPM received a Vision Award for a new paste monitoring system featuring temperature monitoring as well as upper and lower limit roll-height monitoring. Electrovert received a Vision Award for the new DwellFlex 4.0 variable contact wave solder nozzle. The awards were presented at NEPCON Asia.
Industry News | 2021-09-24 13:31:07.0
Investments over the past 18 months support continuing technology advancements and business growth at the electronics design and contract manufacturing center near Rochester, NY
Used SMT Equipment | Soldering - Wave
Electrovert Econopak Plus Wave Solder System; Model: EPK Plus 400/F; SN: 11877383; Llambda and Omega Waves; 2 Bottom Heaters, 1 Top Heater; Includes USI Opti-Flux External Spray Fluxer; 460v, 3 phase
Used SMT Equipment | Soldering - Wave
EPK Plus 400F 09/1999 440VAC 3 phase, L to R Board Flow, V Fingers, 16" Process width, USI Opti Flux External Spray Cabinet, Convection pre-heat with Top Side IR Heat, Chip Wave, Lambda Wave, N2 Capable, Was used in a climate controlled facility/env
 (1).JPG)
Used SMT Equipment | Soldering - Wave
Electrovert Econopak Plus 400/F Wave Soldering System for Sale Vintage 1997 Specifications: Foam fluxer with 13L capacity Chip wave nozzle LAMDA nozzle VectaHeat Preheater 2 Top side IR preheats Heater size 400mm Appro
Electronics Forum | Mon Feb 28 10:11:27 EST 2005 | jbrower
Hi Ing, My suggestion is to take a good look at your profile(s). The Wave solder machine that I use is an Electrovert EPK I. I use Aim ultra pure 63/37 solder with an older kester flux, 920CFX. I recently switched from kester ultrapure to the aim ba
Electronics Forum | Sat Jan 14 18:07:15 EST 2006 | Sona
I am looking for someone on the East Cost to service the following equipment. Electrovert EPK and DEK 260. We need to also add some convection heaters on the wave machine. We are located outside Philly, Pa If anyone can provide me with this info I a
Electronics Forum | Mon Jul 17 17:37:10 EDT 2006 | russ
Okay, now we can get rolling here. Here is a couple of things about selective wave that Ihave found very helpful 1. Make sure that no parts on back side are in excess of .15". if they are we skip; out in SMT and handsolder if labor costs justify.
.png)
