1090 electrovert omniflo 7 reflow oven jmw results

Full Site - : electrovert omniflo 7 reflow oven jmw (Page 9 of 33)

5 zone reflow oven

Electronics Forum | Fri Feb 25 16:16:01 EST 2005 | pjc

Here are some 5 zones models to look for: Electrovert OmniFlo5 Conceptronic HVA70 BTU VIP70 Vitronics SMR or XPM 520 Heller 1088 (4 zone)

Electrovert Omniexcell 7 Center Support

Electronics Forum | Mon Jun 24 13:01:24 EDT 2013 | quaker332007

Can anyone help me with the center support on this oven? The support is rising up to high and causing the board to rock during reflow. Is the away to lower the center support?

Soldering oven

Electronics Forum | Mon Jan 19 08:37:16 EST 2009 | lkpdsund

Hello all! We possess a speedline electrovert omniflo 7 reflow oven at my site. Last week we examined how the solder profile was affected by fan-speed and by providing the soldering process with compressed air(O2) or nitrogen(N2). We also ran the sa

8 Zone Vs 7 Zone Reflow Oven

Electronics Forum | Mon Nov 08 06:37:19 EST 2004 | zzikester

If your in the UK call Contax 01489 885808, they sell the Omniflos and they will answer your questions.

Replacement for nitrogen in the reflow oven

Electronics Forum | Wed May 26 17:46:02 EDT 2004 | pjc

Electrovert has hard data on electrical and N2 consumption for the new OmniEXCEL series ovens to compare with preceeding OmniFlo series. Have a look.

Replacement for nitrogen in the reflow oven

Electronics Forum | Mon May 24 12:54:25 EDT 2004 | pjc

Maybe here's an opportunity to get a new oven. Electrovert, BTU and Vitronics offer closed-loop N2 control as an option. This, together with other improvements on oven design can reduce N2 consumption by as much as 40%. Not to mention reductions in e

Reflow oven

Electronics Forum | Fri Jun 26 10:33:08 EDT 2015 | Asif

Hello Professionals, Good morning, We are circuit card manufacturer for the Aerospace industry with low volume and High mix level. We have a plan to Purchase a NEW REFLOW OVEN. Currently we are using Electrovert BRAVO reflow oven which is about 8 yea

SMT Express, Volume 5, Issue No. 7 - from SMTnet.com

Non-wetting: PTH on double-side reflow

Electronics Forum | Wed Apr 06 11:10:47 EDT 2005 | smt_rookie

We process a double-side reflow board (10 ups). Chips and IC's on the bottom side while chips, IC's plus thru-hole connectors and IC sockets on top side (bottom side first then top side reflow). In the past, we were not encountering any soldering pro

Omniflo 7e schematics + Manuals

Electronics Forum | Wed Jan 19 14:43:51 EST 2011 | davidalvarez

Im looking for manuals + schematics and repair information for an electrovert omniflo 7e reflow oven manufactured in 1999, also intrested in the Bill Of Materials if available. Any information on where these can be obtained and where replacement part