Parts & Supplies | Board Cleaners
Baldor Motor 10HP 215TC, CEM3711T with Sonic Air Systems Sonic 70, 460VAC 3 phase power. Removed in working order from an Electrovert Aquastorm 200 Inline Water Wash Machine with a Sonic Air Systems Model Sonic 70 - see pictures for specifications
Used SMT Equipment | Conveyors
Speedlines Camalot1818 Underfill Agilent SJ 50 AOI Universal GSM PTF Panasonic FCB-2M Flip Chip Bonder Speedlines MPM accuflex Solder Paste Printer DEK 265 GSX Solder Paste Printing Autolink Engineering PTE LTD R4200 Offl
Electronics Forum | Wed Jan 24 22:38:45 EST 2007 | electrovert
Hello, My first time post up here. I have a problem with thermo runaway on upper zone #5 on the Omni 10 Electrovert. We changed the thermocouple #5 but the problem came back up. We swapped Sensoray board 8 and 9, swapped board #3 (T/C interface boar
Electronics Forum | Thu Jan 25 15:58:49 EST 2007 | slthomas
Does the t/c read the actual skyrocketing temperature (you could confirm with a profiler if you wanted to leave it running while it's setting itself on fire) or something much lower than reality, driving the heaters harder? I would probably start sw
Electronics Forum | Sat Jul 01 00:20:08 EDT 2017 | aemery
Kelly, it's been a long while since I repaired a BRAVO. The machine was a little unique as far as Electrovert ovens go. I am pretty sure that it is the only Speedline model that integrated a PLC. Loved the OMNI's, not so much with the Bravos. I a
Electronics Forum | Tue Jun 20 16:41:12 EDT 2017 | kkrestchmer
We have a Speedline Electrovert Bravo 8 reflow oven. We have issues where we get a "thermal runaway HTSC trip" error and the oven shuts down. We normally can unplug and replug a connector into the Sensor/Relay Watlow AnaFaze TLM-8 module and it sta
Electronics Forum | Fri Jun 23 12:21:29 EDT 2017 | rgduval
I'm going to guess that you've tried Speedline with no success. They're awfully annoying about their older machines. Things to check: - Thermistor for the zone working properly? - Opto for the zone working correctly? - Heaters working correctly? -
Electronics Forum | Tue Jun 25 22:22:22 EDT 2019 | proy
We have an electrovert 16" econopak wave solder machine with two identical pots (exchange between Tin Lead and Lead Free). When the pots are exchanged the same thermocouple is used, and the same controller is used - with the set point adjusted. The S
Electronics Forum | Tue Sep 13 11:05:38 EDT 2011 | nucleartoast
I worked for Electrovert for 20 years as a machine designer. Our first computer controlled solder machine the Century 2000 used Infra red pyrometers that were very accurate - once you calibrated it against what you wanted to measure. So the aim and s
Electronics Forum | Thu Oct 25 10:05:05 EDT 2012 | kz9yyc
Hello all, I am having difficulty with an OmniExcel 10 oven. Zone 5 upper will not hold setpoint = 165C (it typically runs ~10C higher). Here is what I know: 1. The machine is not turning on zone 5 heat when temp is too high. 2. Zone 5 lower is
.jpg)
