Electronics Forum | Fri Jun 24 13:56:05 EDT 2005 | John S
This is a little late, so I hope you've been in contact with E-vert. We've experienced the same thing on our two vectra's. It normally happens right after a bad electrical storm. The shared drive will have to be reprogrammed. E-vert can fax you a
Electronics Forum | Fri Jan 24 09:26:29 EST 2003 | pjc
I sent you a couple of charts to assist with your troubleshooting. One is the Electrovert Wave Solder Troubleshooting chart and the other is Sandia Labs/Electrovert Optimum Solder Contact Time. Electrovert has a 6 deg. conveyor angle standard on the
Electronics Forum | Tue Aug 24 05:02:55 EDT 2004 | dj_jago
Hiram, We have just had the same decision to make! I was at Vitronics Soltec, Holland about 4 weeks ago doing trials for Lead Free. The Soltec Delta machine was ultimatly chosen over price verses performance. Both machines are very capable but
Electronics Forum | Mon Jun 27 15:02:55 EDT 2005 | cmiller
Thanks for the reply. I had the instructions out of the manual but after re-programming we had all kinds of wierd stuff going on. After re-setting the PC several times it worked fine. Can I get a copy of the instructions you have? It would be appreci
Electronics Forum | Wed Jan 11 15:17:23 EST 2006 | pjc
I heard from Electrovert's engineers that the SnCu alloy has a really tight process window and is not very machine friendly. It is pretty much used exclusively by the consumer electronics folks. They�re always pinching pennies and are running, lets s
Electronics Forum | Fri May 11 09:17:12 EDT 2018 | charliedci
I have used a 2006 Electrovert Vectra ES (63/37) for last 3 years, we acquired it used. It had little or no maintenance before we got it, now after replacing a solder pump motor, preheater fans and thermocouples it is pretty reliable. The spray fluxe
Electronics Forum | Fri May 05 11:58:25 EDT 2000 | John Sims
We are using NR300F from Alpha. Topside board temp is 220 deg. F. We have 3 bottom side convection preheaters, and we use a foaming fluxer. The machine (except for the rotary chip wave) is almost identical to the old econopak. An electrovert appl
Electronics Forum | Mon May 08 16:01:11 EDT 2000 | John
I was running the conveyor at 3.75 when we started the discussion with Electrovert. Unfortunately, foam fluxing is a fact of life for us. Our products have open contact relays that can become contaminated by spray fluxing. Titration is our only me