Electronics Forum | Mon Dec 03 10:53:08 EST 2007 | slthomas
Sometimes when I get one of those messages I wonder if we're not dealing with a Japanese/Dutch/English translation issue. In the words of Willie Dixon, "It Don't Make Sense".
Electronics Forum | Thu Dec 14 16:47:53 EST 2017 | jeffr
You should replace the Brushes first. If it continues.. you must check the wire continuity back to the controler and possibly replace the Motor
Electronics Forum | Sat Dec 01 18:08:03 EST 2007 | jmelson
Hello, I just ran into a crazy problem with my CSM84. I did a batch of one side of a board, then loaded the program to do the top side, and it stops with the head over the 3rd component's feeder, and reports error 117:overflow. The maintenance manua
Electronics Forum | Thu Dec 14 21:56:25 EST 2017 | jmelson
I checked the brushes, there is lots of length left on them, and the springs and pigtails are in good shape, too. I have been checking various cables, and reseating connectors, but making a resistance measurement from the brush holders back to the s
Electronics Forum | Sun Dec 17 22:23:46 EST 2017 | jmelson
Well, I fixed it. I had resisted taking the motor off because of the recalibrations that would be required. But, it got bad enough I had to. Under the microscope, I could see copper dust packed between the commutator segments. I removed that, and
Electronics Forum | Thu Dec 14 23:21:12 EST 2017 | jmelson
OK, I think you are right! The one brush I can get to looks fine, the other one is on the back, and there's no way to get to it without removing the motor. Even the front brush was VERY hard to get back in. But, there are rubber plugs that allow y
Electronics Forum | Tue Mar 08 10:58:13 EST 2011 | aj
Hi all, This error appeared this morning and prevents me from opening any of the jobs. Everything was working fine yesterday!! Any advise as to how to deal with this? Thanks, Alan...
Electronics Forum | Tue Mar 03 12:36:14 EST 2020 | tomdegas
I cleaned and re-greased everything on the Hydra head and I even changed the motor and encoder and it still gives me the timeout error Z/156. Where do I look now? My machine has been down now for 3 weeks.
Electronics Forum | Sat Apr 04 04:53:58 EDT 2020 | tima
Have you try doing initialization from service menu? Exit TPsys, type service -x and try to initialize only Hydra Z. See what error you get. Can be too much friction on the shaft. Run friction test
Electronics Forum | Thu Dec 21 17:04:28 EST 2023 | cyber_wolf
Disable the hydra head.
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411