Electronics Forum | Mon Jun 12 23:52:58 EDT 2017 | aemery
Don, either you have a faulty park sensor or much more likely the vision gantry Y axis is not reaching the sensor. Possible issues, one of the two VY drivers cards is failing; one of the VY forcer motors (air bearings) is failing; to much air leakin
Electronics Forum | Thu Jun 28 18:50:08 EDT 2018 | caurbach
We don't have your exact machine or know your exact configuration, but our machine has occasionally gotten an estop due to a breaker in the SelectX tripping. Just be aware that there are circuits other than the mushroom switches that can generate an
Electronics Forum | Sat Nov 07 18:38:32 EST 2020 | enzik
Hello to all, The Fuji GSP III screen printer was working well yesterday. This morning, the machine turned on and the display screen was showing nothing. I went to the back of the machine and reset one of the VM1152A. The display screen is now showi
Electronics Forum | Fri May 21 07:57:38 EDT 2021 | sophyluo1985
I'm Quinn form Gooldland China I saw on the forum that you have printing presses using FUJI, Have you encountered a problem that you cannot solve? Maybe we can provide you with some help. Please contact me: Quinn Shenzhen Jing Cheng Zhi Yuan Technol
Electronics Forum | Wed Oct 12 17:45:07 EDT 2022 | rmcmartin
I received an error message from our Sony F209 pick and place machine saying E17 servo controller is in emergency stop. It says the remedy is to cancel the input or replace the cable. where is the E17 servo controller and how do you cancel the inpu
Electronics Forum | Fri May 06 15:15:19 EDT 2005 | lyrtech
Hi, I have an INTERMITENT error on my FUJI IP-2 that cause to me many headaches. The error is " SERVO NOT GOOD". In the books, it means that it is relative to servo amplifier. But I can't assume that is the problem because sometimes the machine wor
Electronics Forum | Fri May 06 16:19:40 EDT 2005 | jdengler
Does the problem happen at start-up? Does the servo amp have an error? If yes to both, could be a bad cable, or a badly tuned servo amp. If after running and the amp has an error it could still be the cable but also brings in things like a bad motor
Electronics Forum | Mon May 09 17:49:28 EDT 2005 | chon
Inspect the cables specially in those area where cables have bendings with the motor motion. If they have something covering them or extra insulation try to remove it and inspect closely. If the machine runs and suddenly stops with this error and aft
Electronics Forum | Fri Apr 15 15:04:02 EDT 2005 | lyrtech
Hi, Sometimes we have the following error: " TABLE BASE NOT GOOD ". In the manual, it says that we have to check the cylinder and other parts around the table. This is not very specific. Can anyone helps us with some hints? Thank you
Electronics Forum | Tue Apr 19 07:52:17 EDT 2005 | lyrtech
Thank you to both of you. I found the solution with your help. Have a nice day
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
