Electronics Forum | Sat Jun 27 17:49:24 EDT 2020 | jmelson
I can't find much info on the older Essemtec machines. First, I'd want to see the "spec sheet", then I'd want to find out what the programming environment is like. (I was really impressed with the Samsung machines in that regard.) I have not seen
Electronics Forum | Mon May 06 10:27:22 EDT 2002 | JCC
What version is your firmware?? This error can be caused bt something as simple as the background nozzle disks. Are you using the old style or the new vinyl ones?
Electronics Forum | Thu Apr 22 09:09:10 EDT 1999 | Scotty
| Recently, we have been having problems with PLCC's passing vision on our IP's If the part is set up to be placed on Head 2, it will not always pass vision. However, if we move it over to Head 1, it will pass and place just fine. Now, I do realiz
Electronics Forum | Thu Apr 22 21:59:21 EDT 1999 | Nik
75) but the right thing is to change the light source in the robot that is rejecting PLCC's..it worked for us!!! | Larry, | | I have seen this problem on our machine with PLCC 28's, same part same PD, same program except head 2 would place head 1 wo
Electronics Forum | Wed May 22 10:27:33 EDT 2002 | stefwitt
Fiducial recognition on the Siemens machine works like the Mydata. Once you select this option, fiducials will be recognized when a new program is send. You can also select recognition as part of the feeder refill function mode. There is no automatic
Electronics Forum | Fri Apr 15 16:02:26 EDT 2005 | jdengler
ING, If my memory is correct: -This is from the large air cylinder below the X/Y table moving slow or not getting down all of the way. -The air cylinder has a sensor for when it's down all of the way. - This sensor could be bad but most of the t
Electronics Forum | Tue Apr 19 05:42:13 EDT 2005 | woodglass
There's two sensors at the rear of the XY table. Make sure that these are functioning correctly. You can view their states in the I/O map. The solenoid which actuates the table base up/down air cylinder is also at the rear of the table, to the left o
Electronics Forum | Tue Mar 09 11:10:31 EST 2010 | baildl632
Graceyt, I know you are being shot a lot of info. Have you gotten any resolution to this problem? I've seen similar problems in our thermal chamber with Demodulation units. The IC, in the module, inside the radio inside the chamber at the top of ou
Electronics Forum | Mon Apr 26 22:25:04 EDT 1999 | Big K
75) but the right thing is to change the light source in the robot that is rejecting PLCC's..it worked for us!!! | | Larry, | | | | I have seen this problem on our machine with PLCC 28's, same part same PD, same program except head 2 would place hea
Electronics Forum | Tue May 16 16:32:38 EDT 2000 | Ashok Dhawan
1) I had downloaded ANSI/ESD-S20.20-1999 from www.eosesd.org web site. I am not clear whether section 6.2.3.2 is correct. It states that " All process essential insulators that have electrostatic fields that exceed 2000 volts should be kept at a mi
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
.jpg)
