Electronics Forum | Mon May 02 23:42:44 EDT 2016 | ttheis
I have a strange issue where all 4 spindles of head 1 on my GSM1 are able to place small parts without a problem until the very end of the routine where a large electrolytic aluminum capacitor is placed. The part is successfully picked out of the fee
Electronics Forum | Mon Jul 30 15:28:25 EDT 2007 | gmoritz
I'm posting a diary of the major repair experience that we had this weekend. I'll follow up with a shorter post that sort of summarizes a few things. ------------------------------------------------ The service guys showed up at our facility about
Electronics Forum | Tue May 03 10:51:41 EDT 2016 | swag
UIC'S newer software has a category you can change to force a part to the back during optimization for this very reason. I think it's done in placement list. Example: A part coded 1000 will place after a part coded 500. I don't recall what it is
Electronics Forum | Mon Mar 25 09:26:16 EST 2002 | stefwitt
you should also look into the different placement methods and their advantages and weaknesses. A chip shooter with a rotary head and lets say 18 nozzles always places one component and picks one at the same time. PC board and feeder table move while
Electronics Forum | Wed May 18 18:36:22 EDT 2005 | global
Ok here's one for ya. We have a DEK 260 with a Cyberbectic vision system, 1 of about only 50 made as told to me by a DEK service Tech. So if anyone has operated one of the other 49 you may be able to help. The Service techs at DEK are not familiar en
Electronics Forum | Wed Sep 04 09:47:41 EDT 2019 | smrsteve
Hello All, I've just bought a Quad 4c pick & place machine. It's so close to actually building boards, but just doesn't quite get there. I was wondering if there's somebody out there with experience of these machines that might be able to help...?
Electronics Forum | Tue Jul 09 15:20:19 EDT 2002 | pjc
When you look at the capabilities of Combo machines they tend to sacrifice performance when compared to separate X-ray and AOI machines, meaning they don't do either the X-ray or AOI operations as well as a machine that was designed to do only one. A
Electronics Forum | Fri Mar 30 11:04:24 EST 2001 | genny
We are already using ICT on the PCB, which should catch most missing components, also components installed backwards, or the wrong value(to a point - we do RF so we have lots of very small value caps and inductors which can't be measured), and in som
Electronics Forum | Mon Mar 11 07:58:59 EDT 2013 | cyber_wolf
So I have this issue with my 1240. During my weekly oven surveyor check I get a software alarm that says I am out of tolerance. Probe #3 which is closest to the hinge side of the oven is approx. 10 degrees hotter in zone 12 than the other 2 probes o
Electronics Forum | Thu Jun 28 20:11:32 EDT 2007 | rfrog
Hi folks, I've been bouncing off of MyData technical support for some time on an issue with a MyData machine. Seems that this My9 likes to skip an 0402 placement at a rate of ~ 1000/million. Profile: MyData My9 Mechanical centering Midas only