Electronics Forum | Wed Dec 14 06:16:50 EST 2005 | Rob
Hi Grant, Murata do 0402 chip caps on 50K reels - example: GRM1555C1H101JZ01J 0402, 100pf, NPO/C0G 50V 5% (make sure the final letter is included - the J denotes the reel size - D is standard 10K) Rohm MCR01 series (0402 resistors) come on 6inch, 1
Electronics Forum | Wed Aug 06 04:11:56 EDT 2008 | chrispy1963
GR@ICS, can you be more specific about your up in the Ersa machine please? Nozzle size, pump rate (%), and is your machine equipped with monitors on the solder pots? We have the same machine it sounds like, however we run Pb-Free in both pots. I
Electronics Forum | Tue Nov 14 13:39:37 EST 2000 | Mark S
Hi All -- I'm about to design a DPAK part (case 369A-13, Issue Z)onto a PCB . The part's maximum length as given in the datasheets (On-Semi MAC4DHM) is 0.030" longer than the recommended land pattern as given in that same datasheet. (1) Has anybod
Electronics Forum | Thu Jul 31 11:33:51 EDT 2003 | yngwie
I faced problem over connecter's pin that were hot air soldered. This connector has 168 pins ( similar to the straddle connector ). The process is to apply the flux onto the connector's J-leads, and the hot air pencil were then ran thru' the leads to
Electronics Forum | Mon Jun 01 14:35:59 EDT 1998 | Rich
| | | | | | Thanks Steve- | | | Here is the whole story: | | | | | | The solder balls are appearing all over, similar to a | | | splatter. They are relatively small. We are using H-Technologies | | | S-HQ no-clean solder paste. The stencil is
Electronics Forum | Mon Oct 16 10:07:11 EDT 2006 | realchunks
Wow, 15 degrees C is too much. Is this a new problem or new oven? If it's a new problem several things you can check out. Thermocouple placement may have got knocked into the wrong spot, or it could be dirty. I've seen this happen after a PM and
Electronics Forum | Tue Oct 01 14:53:24 EDT 2013 | felo188
it's means that a pcb part responsible for second top zone is broken. To make sure i changed second thermocouple and heater with first. Now there is no overshoot. But I have still problem with automatically shutdown. It is turning off after 1 or 2
Electronics Forum | Thu Jun 06 13:04:50 EDT 2013 | williamaxler
I used method 'A' but I leave the wave on. I use a stainless steal brush like 7248T13 on McMaster-Carr.com. This way I can apply the acid and scrub the nozzle. Another important part is get a small brush to push down into the nozzle to make sure y
Electronics Forum | Tue Oct 29 15:55:16 EST 2002 | babe
If you are using a low end hot air system IE: Weller, Hakko or Pace then your problems are with the system and not necessarily with your process. However process is important. We have found by inspection with an Ersa Scope (BGA inspection system) tha
Electronics Forum | Tue Oct 19 14:56:55 EDT 1999 | JohnW
Nick, I've run this flux for a while and it's not too bad. There is a tendancy for there to be residue left on the PCB after wave due to the solid's content but it can be minised by putting some effort into setting up your spray fluxer to an optimum
.gif)
.gif)
