Electronics Forum | Wed Feb 08 22:05:54 EST 2017 | cromaclear
Hello to all, I am using ersa versaflow 3 selective soldering machine, i am having problems with nitrogen gas ring contamination. How can i clean this rings,what do you use? Ultrasonic bath maybe?
Electronics Forum | Thu Apr 20 02:17:15 EDT 2017 | cromaclear
Hello to all, I am having a serious problem on my ersa versaflow 3 machine. This is a selective soldering machine and a problem is in less soldering material on the pins, you can see it in the picture http://imgur.com/a/FC2a1 Do you have any idea how
Electronics Forum | Mon Jan 20 11:11:24 EST 2014 | fnorradd
I have an Ersa Versaflow selective solder machine (single bath) which runs via a Profibus control system. I have checked all of the settings on the inverter, and all of the connections and outputs throughout the machine, but the machine returns a 68
Electronics Forum | Wed Dec 14 06:16:50 EST 2005 | Rob
Hi Grant, Murata do 0402 chip caps on 50K reels - example: GRM1555C1H101JZ01J 0402, 100pf, NPO/C0G 50V 5% (make sure the final letter is included - the J denotes the reel size - D is standard 10K) Rohm MCR01 series (0402 resistors) come on 6inch, 1
Electronics Forum | Wed Aug 06 04:11:56 EDT 2008 | chrispy1963
GR@ICS, can you be more specific about your up in the Ersa machine please? Nozzle size, pump rate (%), and is your machine equipped with monitors on the solder pots? We have the same machine it sounds like, however we run Pb-Free in both pots. I
Electronics Forum | Tue Nov 14 13:39:37 EST 2000 | Mark S
Hi All -- I'm about to design a DPAK part (case 369A-13, Issue Z)onto a PCB . The part's maximum length as given in the datasheets (On-Semi MAC4DHM) is 0.030" longer than the recommended land pattern as given in that same datasheet. (1) Has anybod
Electronics Forum | Thu Jul 31 11:33:51 EDT 2003 | yngwie
I faced problem over connecter's pin that were hot air soldered. This connector has 168 pins ( similar to the straddle connector ). The process is to apply the flux onto the connector's J-leads, and the hot air pencil were then ran thru' the leads to
Electronics Forum | Mon Jun 01 14:35:59 EDT 1998 | Rich
| | | | | | Thanks Steve- | | | Here is the whole story: | | | | | | The solder balls are appearing all over, similar to a | | | splatter. They are relatively small. We are using H-Technologies | | | S-HQ no-clean solder paste. The stencil is
Electronics Forum | Mon Oct 16 10:07:11 EDT 2006 | realchunks
Wow, 15 degrees C is too much. Is this a new problem or new oven? If it's a new problem several things you can check out. Thermocouple placement may have got knocked into the wrong spot, or it could be dirty. I've seen this happen after a PM and
Electronics Forum | Tue Oct 01 14:53:24 EDT 2013 | felo188
it's means that a pcb part responsible for second top zone is broken. To make sure i changed second thermocouple and heater with first. Now there is no overshoot. But I have still problem with automatically shutdown. It is turning off after 1 or 2
.gif)
.gif)
