Electronics Forum | Mon Aug 08 06:17:09 EDT 2005 | Hi Steven
My suggest is using Ersa IR55A or IR650A. http://www.ersa.de/en/ If you looking for your quality, you need this system. I had try it many time, is better then hot air. and you can set the profile as you like, even Flat Peak on the Lead Free Rework.
Electronics Forum | Fri Dec 02 09:12:20 EST 2005 | chunks
We have both Ersa scope and X-Ray. Everyone uses the X-ray because it's a quick way to check for shorts, which seems to be the line supervisors only concern when it comes to BGAs. The Ersa is fine, but it's only real use is to examine a couple of r
Electronics Forum | Sat May 05 11:57:52 EDT 2007 | mohdfazuwan
i'm looking for BGA Rework Station - Temp Profiler for ERSA. Rit now i facing problem the Temp profile easy to drift from initial setting. Hope some one can advise me what type of Temp Profiler suitable for Ersa BGA Rework station. Hope the profiler
Electronics Forum | Tue Jan 14 11:34:44 EST 2003 | jsherrow
I have an AirVac DRS24 and older Ersa IR station. Happy with the DRS. Can't speal for SRT had a hard time setting up a demo with the rep.
Electronics Forum | Tue Dec 03 14:05:09 EST 2013 | chadsuckow
You can have it either way. In each program you can select to have the side pressure active for the entire program. The factory setting is to have it release immediately after it pushes the pcb against the fixed rail.
Electronics Forum | Wed Jan 09 08:36:13 EST 2002 | marquesj
For Pick & Place machines you have Siemens Machines, visit - http://www.siplace.com They are good machines and they have a nice support For loader and unloader you have Nutek visit, - http://www.nutekholdings.com/A5581E/hpage.nsf/Main!OpenFrameSet
Electronics Forum | Wed Dec 13 15:19:32 EST 2023 | hhudson
It has been happening in the mornings, and we do have a weak middle element, but our temp is always above 60C. we have it set at 65C. the service manager for the machine assured us that temperature wasn't the issue. Also, our flux application for ERS
Electronics Forum | Fri Apr 20 10:17:47 EDT 2018 | sarcher
We purchased a ERSA Wave Solder 330-F machine recently "As Is", with NO warranty. Trying to get the machine started, we've ran into trouble with the Spray Fluxer ESF. During the initial verification run, the spray fluxer would move 4 times to the ce
Electronics Forum | Thu May 17 09:53:14 EDT 2007 | mohdfazuwan
For ur information, this BGA machine was full utilize every day. I have more than 100 model to do profiling every week. Different PCBA with different thickness & material need different temp setting. currently i'm looking for profiler that more compa
Electronics Forum | Thu Jul 03 08:55:37 EDT 2008 | andrzej
Hi, I might say I have some experience (1 year) in wave soldering. Yes I have set all parameters to run PCBs through wave solder. Yes, I have run new products on wave solder and had to find solutions for problems encountered. I understand relationsh
