Electronics Forum | Mon Jan 20 11:11:24 EST 2014 | fnorradd
I have an Ersa Versaflow selective solder machine (single bath) which runs via a Profibus control system. I have checked all of the settings on the inverter, and all of the connections and outputs throughout the machine, but the machine returns a 68
Electronics Forum | Wed Oct 25 07:54:16 EDT 2000 | CAL
We were using a Glenbrook RTX then upgraded to a jewel box. We have been extremely pleased with both Glenbrook units.Glenbrook has great analytical BGA software.Glenbrook and ERSA have also teamed up to provide total inspection solution package. 973-
Electronics Forum | Thu Jul 12 16:18:24 EDT 2001 | caldon
I am not familiar with the ERSA system you talk about but wanted to let you know there is another company call PDR that also uses IR and no nozzles. the machine is pretty slick and easy to use and set up. We have found no adverse affects to the IR he
Electronics Forum | Wed Apr 19 05:29:30 EDT 2006 | dougs
Good point about the cycle time, we've had a think about this issue, we are set up mainly to do small batch sizes, the reasoning for thinking about laser soldering is that there is no requirements for wave solder tooling, on a batch of 50 boards or s
Electronics Forum | Tue Aug 12 13:40:08 EDT 2008 | ck_the_flip
GR@ICS: Are you drag soldering or point-to-point soldering? Keep in mind. Drag soldering mimics wave soldering. Molten solder is contacting and dragging across the solder mask. Keep in mind, too, that "semi-matt" or "semi-gloss" will also tend to
Electronics Forum | Fri Sep 06 06:11:40 EDT 2013 | fnorradd
Hi All, We have purchased an Ersa Versaflow selective solder machine, and I am looking in to profiling upon the machine. We currently have a process for profiling our wave with a WaveRider system, this we use to gauge that the machine is set up cor
Electronics Forum | Tue Jul 21 05:08:16 EDT 2020 | arty vesna
Hi there. I am currently kinda in the same spot as the author of the thread. My choice is between Rehm VXC and Heller 1809. I am a little concerned about Heller advertising their 25cm/10 in zones. I am used to large ovens designed for high throughput
Electronics Forum | Mon Apr 29 13:56:19 EDT 2013 | williamaxler
We have a Versaflow 40/50 and ours is setup like this. We have out nozzle test position set so that in the Z axis you are 3.8mm away from the pin. Used feeler gauge Then you can set your gradient per nozzle. Start with a number then do a wave offs
Electronics Forum | Thu Jun 10 13:29:21 EDT 2021 | edgar_smt_ap
Good morning. What should be the Oxygen content Standard in an Oven? Here in my company, we have an ERSA reflow Oven, and we work with Lead Free solder paste. According to Work Standard documents send by my company corporate, the PPM Oxygen conte
