Electronics Forum | Wed Jul 09 16:09:47 EDT 2003 | russ
I would always recommend that an oven be used. I am not familiar with the ERSA rework system so I cannot comment. The key is to heat evenly with the correct ramp rate. If your rework station does this well then use it. if not I would put through t
Electronics Forum | Tue Aug 27 16:39:39 EDT 2019 | spoiltforchoice
There is no formula out there that chooses a model for low volume high mix. Every oven can manage the throughput, which leaves us with cost, servicing, flexibility and reliability. Ersa Pros: Longer heated length than the ovens I am comparing it t
Electronics Forum | Thu Jun 10 13:29:21 EDT 2021 | edgar_smt_ap
Good morning. What should be the Oxygen content Standard in an Oven? Here in my company, we have an ERSA reflow Oven, and we work with Lead Free solder paste. According to Work Standard documents send by my company corporate, the PPM Oxygen conte
Electronics Forum | Tue Mar 20 08:04:47 EDT 2018 | spoiltforchoice
Those of us doing low volume with mesh ovens and double sided boards will often use the titanium strips used for making boards more rigid for wave soldering. Gives you enough clearance for lower profile items that you would typically find on the firs
Electronics Forum | Wed Aug 15 18:16:15 EDT 2001 | Shindler
Hi Larry- Be wary of which IR systems you use, dark IR (ERSA) maintains only the positive effects of infrared use in that this infrared medium wavelength has the optimal absorbtion/reflection ratio between light and dark colors. Therby, guaranteeing
Electronics Forum | Tue Jul 21 05:08:16 EDT 2020 | arty vesna
Hi there. I am currently kinda in the same spot as the author of the thread. My choice is between Rehm VXC and Heller 1809. I am a little concerned about Heller advertising their 25cm/10 in zones. I am used to large ovens designed for high throughput
Electronics Forum | Wed Sep 29 12:51:55 EDT 1999 | Bob Barr
Never heard of the DRS-22C. I have had a DRS-22 for several years now. Purchased it when we started doing BGA's. The operators like it - good optics (split view), built like a tank, X-Y table easy to manipulate for alignment. I like it because I ca
Electronics Forum | Sun Feb 05 17:44:47 EST 2017 | spoiltforchoice
Printer->Paste Inspection(which might be a feature of the printer)->High speed placer (for all the little parts)->Accurate Placer(for your BGA Processor,RAM,eMMC and big things that don't fit in the high speed)->Reflow oven->AOI->PCB stacker All of t
Electronics Forum | Fri Nov 07 23:40:41 EST 2008 | padawanlinuxero
I have been working on the SMT area for a while now, must of my experience is on programming and pick and place, now in my new job I have to control a complete SMT line and I have a little knowledge on working with solder paste but I like to read mor
Electronics Forum | Tue Apr 09 21:40:26 EDT 2002 | ianchan
We are a local enterprise with limited resources, just like you described, so hope this experience sharing helps : we place a production Visual Mechanical Inspection (VMI) inspector at the end of each Reflow Oven area, complete with magnify scope 30
.gif)
