Electronics Forum | Sun Jun 24 12:45:51 EDT 2007 | Frank
I never thought about painting our copper piping. I always thought the patina that covers the pipes adds a bit of history and class, ya know an antique-feel, to the shop. I was in a shop years ago that used PVC piping for their air. From looking a
Electronics Forum | Thu Sep 04 14:39:35 EDT 2008 | bschreiber
Jim, There are several articles on Misprint cleaning at http://www.smartsonic.com/article.html including the "Stencil and Misprint Cleaning Handbook" by the IPC. Real Chunks, We have replaced several pneumatic stencil cleaners over the years that we
Electronics Forum | Mon May 05 13:40:28 EDT 2014 | rway
The vent is there for reasons as the name implies. It's a safety feature to prevent the cap from exploding if over-tasked. Yes, without the relief on the end, the caps have a potential to become missiles when they go. I had one go off when my hand
Electronics Forum | Sat Jul 27 00:27:41 EDT 2002 | fastek
Cal- Your statement about Fuji owning the market in the 80's is not quite true. If you look at what was happening in those days...before CM's had any penetration, Panasonic was the big dog because they targeted the OEM's and crapped on the CM's. Mad
Electronics Forum | Fri Apr 02 00:16:18 EST 2004 | Mike Konrad
There is no shortage of reasons to clean your boards. Soldering or reflowing your boards leaves �stuff� on them. This �stuff� is normally corrosive and conductive (some fluxes / pastes are more corrosive / conductive than others). In either case,
Electronics Forum | Mon Jul 26 19:37:47 EDT 2004 | Grant
Hi, It was funny. The sight of 3 men standing around the microwave daring each other to push the start button, and then freaking out when the whole thing looked as though it was going to explode was funny. I guess you have to try these things! Tho
Electronics Forum | Tue Jun 23 13:50:05 EDT 2020 | dltechltd
505.05 SP2 Hotfix3 After this, we were able to work with the machine until 1 week and the machine broke again. A small zener diode exploded on a Servo card, and we replaced it. Next reboot, the MC system halted, because an SRBS error. We have aske
Electronics Forum | Sun Jul 26 07:52:35 EDT 2020 | sync40
Hello to everyone, Have you ever experienced soldermask bubbles inmediately after printed the soldermask itself? (for screen printing method of LPISM). I am not talking here about blistering or any outgassing defects after exposing to high temperatu
Electronics Forum | Tue Jan 23 11:55:27 EST 2001 | aiscorp
I gather from your question that you might have experienced large scale system implementation problems in the past, or at least fear experiencing it in the future. This is a very valid concern based on the performance of traditional CIM systems. Fo
Electronics Forum | Wed Feb 21 16:14:44 EST 2001 | billschreiber
120 degrees F (49 degrees C.), check the fine-pitch apertures for shape distortion (stainless steel has a very poor memory, once it expands, it doesn�t always contract back to the same position). Check for dings and dents. A good stencil cleaning pr
