Electronics Forum | Tue Apr 02 19:13:02 EDT 2024 | mistrthou
Nice. BTW, I found a pic online. https://www.flasonsmt.com/Uploads/6528ca4e9c5b7.jpg I'm surprised it doesnt have that stuff underneath the machine behind the large panels. Thats where we kept ours.
Electronics Forum | Thu Feb 06 20:23:35 EST 2020 | bilalfarooqi
Hey everyone, We use a MyData MY12 machine and we are experiencing a problem with the Midas head. I recently replaced a torn vacuum tube that goes on the zfib card. The machine worked perfectly for a day and a half but now MY12 has completely stoppe
Electronics Forum | Fri Feb 07 11:06:50 EST 2020 | rgduval
Start by checking cables. Odd that the C-motor would initialize, but, then, theta fails when you move the Z-motor. Sounds like something's got a loose connection somewhere. Possibly in the connector going into the C-motor. If that's a no-go, try
Electronics Forum | Tue May 07 13:51:51 EDT 2013 | shankar2013
acceleration is set to lowest. Ribbon cables were replaced, theta motor replaced. I also see a message pop up just after F-MOT1-26/156:MOVFI: MOTOR TIMEOUT / F-AXIS-182:C-AXIS NOT properly out when expected / 25v reads 3V. Now all these messages
Electronics Forum | Tue Mar 04 17:17:29 EST 2014 | catsem23
Hi I'm trying to pick and place a lot of sod523 components with a mydata my12. I'm using C14 standard tool and Hydra tool H01. For some reason no matter what I try to do when the head picks the component with the C14 tool the machine emergency stops
Electronics Forum | Fri Sep 05 09:22:53 EDT 2014 | rgduval
Hi, Rebecca, Hmm...two x motors? I'm a couple of years removed from MyData's, but, I don't remember two x-motors. Might be something in the My12's that I didn't see in my older My9 (and certainly not in my TP9). As to the small board...unfortun
Electronics Forum | Fri Feb 14 16:01:28 EST 2020 | bk
On the my12 the panel on the front of the machine comes off two screws each corner to loosen the panel. There is a pull out tray that gives you easier access to the computer, ps3, etc. It will be the box in the center on top it should label where eac
