Electronics Forum | Sat Feb 22 09:41:44 EST 2020 | tomdegas
I am getting a F-MOT-MSEDYN HYDRA Z/156 error when I try to initialize Hardware on my My9. Interestingly though when I go into the "Service" program, I can initialize the Hydra Z with no problem. But when I try in TPSys, it doesn't pass and I get t
Electronics Forum | Thu Mar 28 17:00:32 EDT 2024 | kingkelvin
For the hydra camera z-level - there is short section in manual - mentions using metal ruler to cover the camera - but for the other cal steps - I see nothing in the manuals for instructions - so I don't know if any special jigs are needed? I don't h
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Fri Feb 07 11:06:50 EST 2020 | rgduval
Start by checking cables. Odd that the C-motor would initialize, but, then, theta fails when you move the Z-motor. Sounds like something's got a loose connection somewhere. Possibly in the connector going into the C-motor. If that's a no-go, try
Electronics Forum | Fri Feb 07 13:17:32 EST 2020 | bk
I am assuming you are initializing each motor individually through the service program. The z motor theta is hard to see so I put a mark on it with a colored marker so you can watch if the midas tool nozzle is actually turning or not. You should be a
Electronics Forum | Mon Apr 08 15:39:10 EDT 2024 | mistrthou
The error is: MOT-Command/205: Motor speed out of control Motor speed deviates from expected speed. – Problem with power supply, motor current too low. – Mechanical problem, friction too high or tool stuck in Z. I'd be looking at excessive friction
Electronics Forum | Fri Feb 14 16:01:28 EST 2020 | bk
On the my12 the panel on the front of the machine comes off two screws each corner to loosen the panel. There is a pull out tray that gives you easier access to the computer, ps3, etc. It will be the box in the center on top it should label where eac
Electronics Forum | Tue Mar 04 17:17:29 EST 2014 | catsem23
Hi I'm trying to pick and place a lot of sod523 components with a mydata my12. I'm using C14 standard tool and Hydra tool H01. For some reason no matter what I try to do when the head picks the component with the C14 tool the machine emergency stops
