Electronics Forum | Sat May 29 14:03:18 EDT 2010 | padawanlinuxero
Hello guys! I have a problem I had to change the MI Board on a MYDATA TP9-4 machine because it was firing 3 or more feeders at the same time, after the change it run great but then for some reason after a while it start to show an error message that
Electronics Forum | Wed Aug 07 13:32:21 EDT 2019 | rgduval
To isolate the MOT failure, try swapping the MOT card with another MOT card. If the failure moves, then the problem is in the card. If the failure does not move, the MOT card is not your problem. If the MOT card is not the issue, then your problem
KD Electronics Ltd. | http://www.kundasmt.com/?A-Equipment-Accessories/6010.html
03081431S01 hybrid step motor cpl. X12/X16 V2 03081445S01 Set move stop, prepared kit gantry modu 03081446-01 Nozzle magacine type 30xx 03081570-01 Guide rail 03081574S03 COT-Insert MT 60 03081585-02 Table Module MT 60 03081586-01
GPD Global | https://www.gpd-global.com/co_website/pdf/doc/Side-Mount-Loader-Unloader-Guide-24000600.pdf
Detects the presence of a substrate in the gap. Magazine will not move to the next slot when this sensor is active. E Magazine_Up Not shown. Detects magazine presence on upper tray. F Magazine_Dn Not shown. Detects magazine presence on lower tray. G Pusher
