Parts & Supplies | Pick and Place/Feeders
MOT-1 ED-2F Rev. 0 OK: MA Date: 1996.04.14
Parts & Supplies | Pick and Place/Feeders
MOT-1 ED-2F Rev. 0 OK: MA Date: 1996.04.14
Electronics Forum | Sun Oct 24 08:07:06 EDT 2021 | artem
Hello, I have a Mydata TP11-UFP which stopped working. It prints F-MOT1-38/245:MSETDYNX during initialisation. Any idea what could be wrong? I have already replaced the capacitors and the Inrush Current Limiters on the "L-19-588-18" board. Also ins
Electronics Forum | Tue May 07 12:30:30 EDT 2013 | shankar2013
We are having a problem with our Mydata TP9-2U where the machine shuts down during a job with this message seen on the service monitor -- F-MOT1-26/156:MOVFI: MOTOR TIMEOUT Has anybody seen this problem?
Electronics Forum | Tue Oct 26 15:47:37 EDT 2021 | harry
I just got the same machine with very low hours. What has been your experience? This is my first mydata machine.
Electronics Forum | Fri Oct 29 17:48:46 EDT 2021 | artem
Hello, I have found the problem. The capacitors on the PAIB board were leaking. They have even demaged some traces and vias on the PCB and the -5V supply on the PAIB board was not working anymore. Got it working again :)
Electronics Forum | Tue Jan 16 10:45:36 EST 2007 | PaulD
Im looking for some help I have a tp18 that will not initiate the error is f-mot1-38-245:msetdynx I tried several things. I've swapped mot cards to not avail, checked the long ribbon cable and so forth if anyone knows what this code means it would be
Electronics Forum | Mon Oct 25 11:20:52 EDT 2021 | bk
The 245 error is with your x belt motor not the x wagon motor. double check all the fuses on the back of the machine where your power comes in there should be 3 of them. if you haven't changed your blue cables in a while I would change those out. you
Electronics Forum | Tue Jul 22 09:12:58 EDT 2008 | chiptargets
Hi, I posted a similar message yesterday, but I believe it did not make it through properly. I apologize. We have an error while trying to perform Initiate Hardware test. The error was "F-MOT1-25/205:MOVZ: Motorspeed Out of Control". The error, ho
Electronics Forum | Tue May 07 13:51:51 EDT 2013 | shankar2013
acceleration is set to lowest. Ribbon cables were replaced, theta motor replaced. I also see a message pop up just after F-MOT1-26/156:MOVFI: MOTOR TIMEOUT / F-AXIS-182:C-AXIS NOT properly out when expected / 25v reads 3V. Now all these messages
