Electronics Forum | Mon Jun 13 16:17:30 EDT 2005 | peter ng
Dear all, We faced some major issue in setting our company target to 500 points per million at machine throw rate.It might be caused by human error,machine,feeder,environment or other factor.We need some opition and advise on how to achieve this targ
Electronics Forum | Thu Jun 15 08:44:18 EDT 2006 | jdengler
Bert, The original IP feeders do a poor job of peeling the cover tape. Things to check: -All teeth present on the take-up reel -Take-up reel has even drag as it rotates (reel out of round or dirty) -Take-up reel drag is not too high (locations and
Electronics Forum | Sat May 08 08:35:30 EDT 2004 | Grant Petty
Hi, Thanks for the info, and that's the kind of info I am looking for. We need very high reliability, and machines that constantly work at high speed for long periods of time without constant feeder and placement issues. We are finding some issues w
Electronics Forum | Wed Sep 21 12:30:03 EDT 2005 | Rob
Hi Greg, We've used lots of machines over the years & seen lots of different tape related issues - the main one being snap off of the cover tape, usually due to too much glue, over entusiastic heat seal, or a feeder requiring maintainance. Also the
Electronics Forum | Mon Feb 04 19:24:37 EST 2008 | swag
We have an Advantis and it's great for low volume, high mix (flexjet head). If you have good CAD data to upload, it takes little time to program as you can update vision on parts and placements while you are actually building boards ("NPI mode"). I
Electronics Forum | Sun Oct 10 00:47:01 EDT 2004 | Grant
Hi, I checked one out in Taiwan recently, and they had two NXT systems on the booth. I think they are very exciting, and being able to change the mounter head and camera, and dual lane is good for through put. However each bay is only 20 x 8mm feed
Electronics Forum | Thu Jun 01 04:51:21 EDT 2006 | EC
Hi TS, Most of the machines will face this problem after been using few years.....I handling SMT equipments ( Fuji machine ) and process.....sorry if I have offened you...... Hi Jack, Firstly, you must able to tell which component having a high thr
Electronics Forum | Wed Dec 20 10:44:31 EST 2017 | bobpan
The z-rod bellows on head 2 and head 3 are slightly bent. The machine will show you this error if the runout is over 6.5 mils. This is usually caused by too much z when picking parts out of a vib or tray feeder. The machine will probably run. I ha
Electronics Forum | Sat Jun 05 07:47:47 EDT 1999 | Dave F
| | | Has anyone had a problem with the trailer tape length being too short and causing placement machine to stop for parts exhaust (SMT parts)? I realize the EIA spec. is set for this length but would like to know what issues you have had. Thanks
Electronics Forum | Fri Mar 05 15:52:03 EST 1999 | Scott Cook
| We are currently looking into purchasing a high volume, medium mix production line. We are considering several different vendors and I would like to know if current users of Siemens equipment are happy. Are the machines maintenance intensive? Ho