Electronics Forum | Fri Feb 15 08:31:03 EST 2013 | cyber_wolf
I believe you need 1.5.13 or higher if I'm not mistaken to run the mags with the button upgrade. There is no way around it that I am aware of.
Electronics Forum | Mon Nov 07 17:11:45 EST 2005 | slthomas
Not sure which vintage you need but http://www.goppm.com is as good a place to start as any for Quad stuff.
Electronics Forum | Wed Apr 18 15:10:35 EDT 2012 | smtivan
Dear Colleagues! Our organization has a lot of not-intellectual feeders for Essemtec Pick&Place CSM7000, but we would like to use this feeders in Essemtec CSM7100. Does it possible? What will we need to do for normal work of CSM7100 with old feeders
Electronics Forum | Fri Jul 29 11:31:44 EDT 2022 | jojoled
Hi Guys, I have Juki PnP machine with 2 heads, and for some reason, whatever I do, I can not make the machine to use 2independent feeders for parallel picking up single component reference by both heads from 2 feeders. Example , imagine you have a
Electronics Forum | Mon Nov 07 09:57:43 EST 2005 | james
Does anyone else know where you can purchase parts for quad 8mm feeders instead of directly buying them from TYCO. In the past 2 months their costs went up over 50%. I order the pins already from another vendor but that is it. Thanks
Electronics Forum | Wed Sep 04 12:55:51 EDT 2019 | dwl
Sounds like its just rejecting parts. Either the length and width of the component is wrong or the tolerance is set too tight. I don't remember the function codes to edit the tolerance but I left them at 30% (the max) and never had any problems with
Electronics Forum | Thu Sep 05 12:40:57 EDT 2019 | bobpan
Also check the lae on the pickup that is being dumped. I think its function 16....make sure that the alignment type is 0.
Electronics Forum | Tue Aug 02 14:05:42 EDT 2022 | jojoled
Hi Evtimov,thanks. Well the "paralell pick" doesnt work at all if place the feeders exactly 104mm apart (for example feeder position 31 and 43) which is exactly the distance of the 2heads..even I put the feeders in 10 and 50 for example, it still pic
Electronics Forum | Wed Sep 04 12:50:40 EDT 2019 | smrsteve
Thanks for that Steve - I'll try anything at the moment, but that sounds like a reasonable suggestion. I've already replaced a few cables that looked dodgy, and the LEDs on the LED rings, but I've not done a ribbon cable on the head yet. I shall hav
Electronics Forum | Wed Sep 04 13:40:46 EDT 2019 | smrsteve
Hello DWL, Thanks for the response. I've measured the components with a micrometer and set the sizes. Maximum tolerance on my machine is 20%, and that's what I'm using. If I do a manual scan, the measurements are exactly right (and what I've set up