Electronics Forum | Tue Aug 02 13:58:23 EDT 2022 | jojoled
Hi Thomas, Seems your machines do what I am looking for. Slight time delay between 2picks is OK,( because the software is not made in multithread way), that is OK.....I just want to have 1x definition of the component in placement data and Component
Electronics Forum | Wed Sep 04 09:47:41 EDT 2019 | smrsteve
Hello All, I've just bought a Quad 4c pick & place machine. It's so close to actually building boards, but just doesn't quite get there. I was wondering if there's somebody out there with experience of these machines that might be able to help...?
Electronics Forum | Wed Sep 04 13:58:36 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the response. 1. Function 30 gives me a consistent 182-185, even after nozzle changes. I can vary this by changing mod code 15 and I have been advised to aim for 90-110, but it doesn't seem to make any difference so I've go
Electronics Forum | Thu Mar 14 10:49:44 EDT 2013 | babe7362000
Have others seen a higher rate of machine downtime due to the cover tape on parts not pulling back properly. We have the same problem on the Jukis and Quads. About every 3 minutes the machine stops and the operator has to pull the tape back. And in
Electronics Forum | Fri Mar 15 08:20:06 EDT 2013 | torch
we quite often see this on our quads usually only on the 8mm feeders, sometimes the tape roller can become sticky as suggested. usually i just remove the roller and apply a grease to the screw so that it can move freely also make sure that the peel
Electronics Forum | Thu Jan 07 15:48:03 EST 2016 | ahanna
Hey everybody! So my Quad 4000c has been acting funny lately. When it goes to dumb a rejected part into the dump bucket it doesn't actually drop the component. This results in it trying to pick up another part with the previous part still on the nozz
Electronics Forum | Fri Jan 08 08:29:48 EST 2016 | ahanna
Water can be the issue. After Christmas break we came back to find a fair amount of water build up in our airlines for the building. I will check out the regulator as well as the solenoid. Thank you. I appreciate it.
Electronics Forum | Wed Aug 19 01:55:18 EDT 2020 | unsung
Hi Jon this marlon Reach out to me to my email marlonquiroz84@gmail.com So I can send you some pics of what could be your error issues. Thanks Marlon
Electronics Forum | Wed Nov 25 05:40:46 EST 1998 | Jim Mitchell
Gang - Thanks for your recent kind comments recently on the QSV-1 machine. As you know, QSoft can import a variety of Windows formats including tab and space delimitted files. It may be that this Cadence software does not export ASCII data. In any
Electronics Forum | Fri Jan 08 06:14:32 EST 2016 | bobpan
There should be a regulator to adjust the puff off on the inside left back panel. Remove the left side cover to get to it. Write down what its set at prior to adjusting it. I have also seen this problem caused by water in the system. Make sure that y