Electronics Forum | Mon Apr 24 08:18:20 EDT 2006 | dirk29
You can do that if you have enough feeder space....but i doubt it unless you have a lot of machines in line.
Electronics Forum | Mon Jun 26 09:33:07 EDT 2017 | bobpan
So I am assuming that you are using the IQ feeders option on the machine. First thing I would check is to make sure you don't have an older feeder on the machine. There was a certain point where quad feeders would be 'IQ' capable or not. You may have
Electronics Forum | Fri Apr 07 17:44:17 EDT 2006 | bobpan
You can either optimize both boards from the very start to the same table top or you can assign the feeders under configure tabletop to the same spot that they were in when you optimized the first program. Remember that you can optimize many differen
Electronics Forum | Mon Apr 24 07:37:57 EDT 2006 | craig_83
We have the IQ system. The problem that I was having is that when I load one board to the other, I want to avoid the table top changeovers. So I figure if I can make certain tabletops to run certain boards the changeovers would be much less. I though
Electronics Forum | Mon Jan 27 10:06:03 EST 2003 | binns
Just to set the record straight... Samsung did not build all Quad machines. QSA = Quad Samsung America, The QSA-30 machine platforms were manufactured by Samsung, utilizing Quad feeders, other Quad technology and Quad sales and service. Before the
Electronics Forum | Fri Apr 07 16:12:37 EDT 2006 | craig_83
I would like to freeze feeders on a global basis. I am tired of table changeovers everytime I run a different board. A good example is today I ran 1 board which went well. I wanted to run a board behind it that had 99% the same parts. I am not necess
Electronics Forum | Wed Dec 30 12:58:10 EST 2009 | vetteboy86
I'm setting up a matrix tray for the first time on our Quad QSP-2. I believe I have defined the tray and holder. Assigned part numbers. My issue is that instead of teach feeders, I think I need to teach table top. When I do this, I am not finding an
Electronics Forum | Sat Oct 10 11:24:50 EDT 2015 | cusackmusic
I've been running Quads for over 10 years, and I love them. I've had almost every model, from the 100, to our current IVCs, and QSP2. We are getting busier, and I'm thinking about upgrading. I have TONS of feeders, so the simple solution would be t
Electronics Forum | Thu Nov 12 04:40:03 EST 1998 | Galen
| Scott - Good to see things are going well for you. With regard to your comments, Quad has introduced a complete line of Semi-conductor/APT machines (Q Series) that support both SMT and Semi-conductor applications. The machines were introduced in
Electronics Forum | Wed Jan 17 13:33:23 EST 2007 | slthomas
We're in the process of trying to select a rebuilt, refurbished, or well serviced flexible placer, something that's capable of placing in the neighborhood of 10k and up. We're a high mix low volume shop so easy setups is key. I'd be looking at a MY-9
