FKN Systek K1000 - Economical Manual and Motorized Depaneling of Pre-scored PCBs Blades Made of Long Lasting High Speed Steel.. Singulate Panels with Components up to 2.5" Adjustable front blade guard for correct scoreline input. Optional Work
FKN Systek K3000 - Singulate scored and skip scored panels up to 24" long ESD protective mat on back table Adjustable front and back support table Singulate panels with components up to 2.5" high Available in 18" blade (standard) or 24" blade (
The FKN Systek K4000 motorized linear blade depanelizer is designed for high volume singulation of scored and skip scored Printed Circuit Boards. No programming necessary. (Switch select operating mode and speed) Singulate panels with components
Safely Singulate Tab Routed Panels - With Dust Extraction Finish routing a tab routed PCB for singulation is a relatively slow process . However, in some cases, where the board contours and sensitive or overhanging components may require, this may b
FKN Systek K2000 - Reduce scrap due to board handling Issues Economical Manual and Motorized Depaneling of Pre-scored PCBs Blades Made of Long Lasting High Speed Steel.. Singulate Panels with Components up to 2.5" Adjustable front blade guard
Industry News | 2016-11-17 15:22:21.0
The N200 punch cleanly separates round and odd shaped panels without dust. Available for under $4,000 from FKN Systek, The N200 is a low cost top down air operated punch for singulating tab routed PCB Panels one tab at a time. An upper and lower matching knife blade is used to pinch the tabs apart.
Industry News | 2022-02-17 12:52:30.0
Cleanly and easily separate a row of up to 10 tabs without dust. Singulating tab routed printed circuit cards in low to medium volume production quantities is safe and easy with the N115 Nibbler from FKN Systek. Two sharp support blades on either side of the tab help cleanly slice the PCBs from the tabs.
Industry News | 2017-01-25 16:39:34.0
Singulating tab routed printed circuit cards in low to medium volume production quantities is safe and easy with the N100 Nibbler from FKN Systek. Blades are available in standard thicknesses of .120”, .093” and .062”. Custom sizes to match the width of the routed section can be ground. Tabs are cut cleanly on each side so that no further clean up is required to remove excess material, as is often the case when using hand tools or when breaking the panels manually. In addition, since only one tab is cut at a time, minimal stress is imparted to the board during the process as the panel is not pressed between two points during the cut.
Singulate Straight Tab Routed Panels Store cut tabs inside tool for discarding at operator convenience Available with 3 blade types and choice of support dies Clean cut - requires no rework for deburring PCB edges Easy blade change in under 5 m
Depanelizer Equipment and Tools For Electronic Assembly. PCB Racks and Trays. Wire Crimp Press and Tooling.
115 Pleasant Street
Millis, USA
Phone: 508 376 2500