Electronics Forum | Thu Oct 27 19:10:36 EDT 2022 | proceng1
My printer handles 1500mm stencil, so no, 4 ft boards print ok. If you are bending the board for the oven, does that mean your printer and PnP handle the full length?
Electronics Forum | Fri Oct 28 19:11:20 EDT 2022 | dwl
Hire a fat guy to sit on them. My rates are very reasonable if you'd like a quote...
Electronics Forum | Mon Oct 31 14:53:52 EDT 2022 | proceng1
Can you share a photo of this board on a carrier? I'm havinga hard time picturing this?
Electronics Forum | Wed Nov 02 01:35:07 EDT 2022 | angela t
How long is the whole strip? Also, what type of pick and place machine are you using?
Electronics Forum | Sat Jan 21 13:49:14 EST 2023 | pcbsino
perhaps we can help you for this SMT and THT part soldering problem, better not bend it not too hard. Electronic manufacturing pcbsino.com
Electronics Forum | Fri Nov 04 12:55:45 EDT 2022 | ibtonystark
We offer to give you the best Lexmark device support that any other company can. Our highly qualified and professional support staff is available around the clock to attend to your needs and provide prompt responses. Feel free to call our assistance
Electronics Forum | Wed Mar 04 07:08:55 EST 1998 | Pat Copeland
I am looking for information on reflow temps for a flex board. There is only one 6 pin IC but the board has a 3M double sided tape. Is it possible to reflow without damaging the tape. Any suggestions?
Electronics Forum | Thu Mar 05 16:25:27 EST 1998 | Brian Stumm @ ETS
| I am looking for information on reflow temps for a flex board. There is only one 6 pin IC but the board has a 3M double sided tape. | Is it possible to reflow without damaging the tape. Any suggestions? Do you have a profiler for your reflow oven?
Electronics Forum | Wed Dec 22 18:09:07 EST 2004 | kmorris
At a previous job I had been taught that when reflow soldering polyimide flex circuits, it was necessary to pre-bake them before reflow soldering to prevent delamination. Our procedures said that there must be a 1hr bake prior to reflow, and the flex
Electronics Forum | Mon Mar 25 16:40:17 EDT 2013 | rrpowers
I have a customer that is wanting to use a low-temp solder paste such as SnBi for a lead free circuit, however they are specifying PET for the flex circuit. I have always used polyimide for SMT reflow due to the temperature limitations of polyester.
