Electronics Forum | Fri Sep 22 12:51:18 EDT 2000 | K. Chak
Hi Folks, Can anyone please tell me the differences between Mil-P-50884c and Mil-PRF- 31032/3. We are dealing with a quote for flex PCB. Thanks in advance Regards Kc.
Electronics Forum | Wed Jul 05 20:50:42 EDT 2000 | Dave F
Hey KC roll-up IPC-A-600 and smack those bums on the nose with it and say "Bad fabricator don't do that on the floor again" in a firm voice.
Electronics Forum | Thu Jul 06 09:26:21 EDT 2000 | K. Chak
Hi Dave, Thanks for the reply. Which part/page of IPC-A-600 Rev F. does it call for? ..may be I am not looking in the right spot. Thanks again. Regards Kc.
Electronics Forum | Thu Jul 06 09:26:24 EDT 2000 | K. Chak
Hi Dave, Thanks for the reply. Which part/page of IPC-A-600 Rev F. does it call for? ..may be I am not looking in the right spot. Thanks again. Regards Kc.
Electronics Forum | Mon Jul 10 20:42:26 EDT 2000 | Dave F
KC: I'm not current to F. Look under "conductor characteristics for "spurious foil." That should do ya.
Electronics Forum | Wed Jan 05 04:40:01 EST 2000 | Karlin
Hi, I am looking for a supplier that can supply polyester PCB in reel to reel form for some low cost flipchip application. Could anyone provide me some contact. rgs chiakl
Electronics Forum | Wed Jan 05 07:06:43 EST 2000 | Christopher Lampron
Chiakl, Advanced Circuit Technology in Nashua, NH manufactures low cost polyester flex in a reel to reel process. They can be reached at (603)880-6000. Hope this helps Chris
Electronics Forum | Wed Jan 12 15:36:36 EST 2000 | Surface Mount Solutions Inc.
Try calling Chris at 513-748-0986 or visit our website at www.flextekinc.com. Mound Flextek is a supplier of low cost reel to reel polyester flex.
Electronics Forum | Wed Jul 16 00:15:38 EDT 2003 | iman
just out of curiousity, why the special nitrogen cabinet concerns for gold plated flex PCB? common "myth/fact" is gold is an "inert" coating layer that is not going to react with room environment conditions *that much?*. Am learning here, so would ap
Electronics Forum | Mon Feb 28 13:31:27 EST 2005 | john
Jerry, Thanks for info. I try to build small flex in panel, alignment is a issue, also the flatness. Do you use vacuum to hold the flex? Do you print in panel of single. Thanks, John