New Equipment | Industrial Automation
Contact: Nancy Lin Email:info@amikon.cn Skype:onlywnn_1 Telegram:+8618020776786 Mobile(Whatsapp): (+86)-18020776786 QQ :2851195456 Control Systems (DCS, PLC/SPS, CNC) - Panel Controllers - HMI and Display Panels - Industrial PC’s - Drives (
Electronics Forum | Tue Jan 16 18:13:25 EST 2007 | greg york
Try to process the composite pallet through the wave without any flux and view volume of smoke and if any residue is deposited in the wave when it exits. My guess is that the pallets are releasing some binders that are high boiling and this in turn c
Electronics Forum | Sat Oct 09 03:45:34 EDT 1999 | Brian
| Right now,we have some problem on SMT. Cause of the flux residue | in the connector. Do somebody have the same symptom? By the way, | can i find something to make the flux observe easy or take a photo with the flux. | | | Unfortunately, this pr
Electronics Forum | Sat Oct 09 03:26:58 EDT 1999 | Brian
| Always experiencing dross in pot with different characteristic such as color, shape, dry/wet etc. Any paper, wetsites provide the more comprehesive explanation on its characteristic | Dross is a mixture of various things. The obvious ones are met
Electronics Forum | Sat Jan 19 02:25:37 EST 2002 | ianchan
Hi, Have a board run, using 63/37 Water Souble (WS) process. during the reflow setup time, we had unsolder issues on a leadless bump chip carrier (BCC) IC level package. To rectify the unsolder rejects, we adjusted the reflow time from 25-55sec into
Electronics Forum | Mon Jan 22 09:28:57 EST 2001 | Adam
The assembly is HASL finished. The colour of the solder mask is green, ( sorry I dont know the technical name ).The flux is No Clean (Koki JS3000)which is seeing a preheat temp between 90-100degCel. The solder pot is set at 250degCel and is 63/37.
Electronics Forum | Fri Apr 16 13:22:48 EDT 2010 | stepheniii
Have you tried running a few bare boards through the oven? If there is no flux on them and you still get the "stains" then I think you can eliminate the flux as the cuprit. And I've been told that white is the second most difficult solder mask colou
Electronics Forum | Tue Jul 08 06:00:29 EDT 2003 | iman
As part of our process/quality improvement review, it was raised thru' our findings that its a good mfg practice to monitor the incoming solder paste quality (as part of the indirect materials). We get one-page "outgoing QC" vendor reports with each
Electronics Forum | Thu Jun 29 06:26:36 EDT 2006 | AR
Hi Slaine, The terminations are still present on the component but all the solder (including the pad finish) has coalesced on to the terminations. The termination that normally is shiny and bright in colour has turned matte grey on that zone where t
Electronics Forum | Mon Dec 18 04:03:30 EST 2006 | greg york
Good solvent wipe will normally show some discoloration of the same colour as resist, but not scientific enough as you cant gauge the amount coming off, ideally none. But is an indicator of the issue. I have been meaning to do a swab with an indicato
