Industry News | 2009-10-09 23:05:14.0
MADISON, AL — October 2009 — STI Electronics, Inc., a full service organization providing training, distribution, consulting, laboratory analysis, prototyping, and small- to medium-volume PCB assembly, announces that it will feature key products and services at the upcoming Space Coast SMTA Expo and Barbeque, scheduled to take place Wednesday, November 4, 2009 from 10 a.m.-3 p.m. at the Lagoon House Education Center in Palm Bay, FL.
Industry News | 2011-08-24 21:38:06.0
From November 15-18, Finetech will exhibit professional system solutions for hot air SMD rework at the Productronica 2011 show in Munich.
Electronics Forum | Tue Jan 13 15:16:12 EST 2004 | drewhmi
A small benchtop system uses a mask, tooled for your part, to arrange the solder spheres onto the BGA, after it has had the excess solder heat-vacuumed off and a new layer of flux applied. The spheres are poured into the cavity, excess decanted off.
Electronics Forum | Tue Jan 13 16:01:06 EST 2004 | russ
I believe that solder paste will need to be applied to this part. I have re-balled these in the past in a low volume situation and here is what I did and there appears to be no adverse effects to the component. Get a stencil (I use 8 mil for .032"
Electronics Forum | Thu Jul 22 21:48:21 EDT 1999 | kyung sam park
Does anyone have any experiences with bga reballing. When I had reworked failed bga part with new part It was good. So I tried to reball bga detached but failed . I guess the cause of fail is thermal shock. IS IT OK TO REBALL BGA PARTS DETACHED ?
Electronics Forum | Thu Jul 22 22:57:14 EDT 1999 | Earl Moon
| Does anyone have any experiences with bga reballing. | When I had reworked failed bga part with new part It was good. | So I tried to reball bga detached but failed . | I guess the cause of fail is thermal shock. | IS IT OK TO REBALL BGA PARTS
Electronics Forum | Mon Jul 26 15:09:31 EDT 1999 | APE South
| Does anyone have any experiences with bga reballing. | When I had reworked failed bga part with new part It was good. | So I tried to reball bga detached but failed . | I guess the cause of fail is thermal shock. | IS IT OK TO REBALL BGA PARTS
Electronics Forum | Mon Jul 26 15:25:27 EDT 1999 | APE South, Jack Reed, Asian Sales Administrator
Dear Mr. Park, Ahn yahn haseo and good day to you. If you are currently in Korea, APE has a direct representative there, Omni-Create in Seoul who can give you full information on BGA reball kits available. Essentially, reball kits are custom made t
Electronics Forum | Wed Jul 22 08:10:24 EDT 2009 | olsa
Hello, this is my first question. More than 10 years my job was mobile phones repair, and for BGA repairing proces I used special template stencil, soldering paste and flux. Right now my job is notebook repair, and I'm interested about reballing of
Electronics Forum | Sun Dec 11 22:39:36 EST 2016 | ppcbs
We have been using the Amtech line for over 12 years now with all of our PCB and BGA Rework. The NWS-4400 is mildly active and will give better results with Lead Free Solder. Note that the LF-4300 is considered a No-Clean. However it will show lea
.gif)
.jpg)
