Electronics Forum | Wed Oct 25 10:33:08 EDT 2000 | Chris
I need to know the advantages or disavantages of a plastic or FR4/Flex based BGA over the ceramic based BGA. We have a BGA package we are going to have produced. Some want to have it made out of ceramic because they feel a ceramic package will be a
Electronics Forum | Mon Feb 15 15:33:47 EST 1999 | Earl Moon
| Any info on the pros and cons of FR4 or Polyamide ref the use of soldering PGAs would be helpful. ie. temp co-efficient diffs, baking, wave soldering, Convection reflow etc | I'm sure you know all the basic differences as Tg, X, Y, and Z expansi
Electronics Forum | Fri Sep 01 10:08:08 EDT 2006 | dmascare
The machines I have been looking at range from about $13K to about as high as $30K. These numbers reflect a complete system with all the various sound enclosures, vacuum systems, starter kits etc. Right now I am looking at 60K rpm spindle machines
Electronics Forum | Wed Oct 25 12:24:02 EDT 2000 | Philip
Hi Chris! I hope this will help you! The CBGA uses an array of high melting point solder spheres(Sn10/Pb90) to connect its ceramic chip carrier to an epoxy glass (FR4) PCB using eutectic (Sn63/Pb37) solder joints at both ceramic and card inter
Electronics Forum | Wed May 06 09:16:51 EDT 1998 | justin medernach
| I hear that there is a problem with using ceramic parts that are sizeable. Apparently, there is a mismatch in the Temperature Coefficient of Expansion between the FR4 and ceramic materials which causes the soldered erminations to weaken and eventua
Electronics Forum | Fri May 15 09:07:12 EDT 1998 | Earl Moon
| | I hear that there is a problem with using ceramic parts that are sizeable. Apparently, there is a mismatch in the Temperature Coefficient of Expansion between the FR4 and ceramic materials which causes the soldered erminations to weaken and event
Electronics Forum | Tue Feb 06 04:54:39 EST 2018 | Robl
Smells a lot worse even with good extraction. Key things to look out for is laser life on your thickness and layup of panels compared to spindle motor life (Typically 10,000 hours, or 2 years for us) and cost of replacement lasers. We get spindle
Electronics Forum | Mon Nov 07 16:34:55 EST 2005 | CW
If I am putting chip capacitors on a .063 FR4 board, what size package should we stay away from to avoid cracking? If I use 2 mil copper on the outside layers of a PCB, am I limited to what pitch of parts I can use? Specifically, will using 0603
Electronics Forum | Mon Nov 07 16:31:47 EST 2005 | CW
hi Bob, Thanks for the info. I understand your comments, but I am looking for specific guidance, If I am putting chip capacitors on a .063 FR4 board, what size package should we stay away from to avoid cracking? (I realize this is dependent on h
Electronics Forum | Thu Jun 15 16:28:48 EDT 2017 | davef
You should be searching on RN Wild, not Roger Wild This might be a good starting point https://supplychain.gsfc.nasa.gov/docs/sc2011j.planteb.pacquetteasof1020.pdf