Double-Sided & Multi-Layer PCB Material: - FR-4 / Hi-Temp FR-4 / FR-5 / G10 / BT / Polyimide - Very Thin PCB: 0.004" 2L ~ 0.030" 8L - Thick Copper: 1/4 oz. ~ 11 oz. Process: - PTH - Blind/Buried/Segmented Via - Sequential Lamination - MicroVia Capa
The LPKF MicroLine 1000 S is perfect for cutting break-out tabs and complex contours at highest accuracy. The benefits include shorter time to market and much higher quality cuts than conventional methods. The machine's UV laser is an optimal tool fo
Laser Depaneling of Populated PCBs Low Cost Option for Depaneling Inexpensive Entry into UV Laser Processing The LPKF MicroLine 1120 S is perfect for cutting break-out tabs and complex contours at highest accuracy. The benefits include shorter
Electronics Forum | Mon Feb 15 14:28:09 EST 1999 | Andy Bellworthy
Any info on the pros and cons of FR4 or Polyamide ref the use of soldering PGAs would be helpful. ie. temp co-efficient diffs, baking, wave soldering, Convection reflow etc
Electronics Forum | Tue Feb 16 12:26:07 EST 1999 | S. Rose
| Any info on the pros and cons of FR4 or Polyamide ref the use of soldering PGAs would be helpful. ie. temp co-efficient diffs, baking, wave soldering, Convection reflow etc |
Electronics Forum | Wed May 13 07:24:12 EDT 1998 | Sherry
Does the temp. profiles used to reflow double sided pcb's through a IR oven on FR4 board material have to be re-established if it is changed to polyimide? Boards will be baked out prior to assembly. any response would be most appreciated.
Electronics Forum | Thu May 14 04:11:33 EDT 1998 | JACK CHEN
| Does the temp. profiles used to reflow double sided pcb's through a IR oven | on FR4 board material have to be re-established if it is changed to | polyimide? Boards will be baked out prior to assembly. | any response would be most appreciated.
Electronics Forum | Tue May 05 17:01:25 EDT 1998 | bob
I hear that there is a problem with using ceramic parts that are sizeable. Apparently, there is a mismatch in the Temperature Coefficient of Expansion between the FR4 and ceramic materials which causes the soldered erminations to weaken and eventuall
Electronics Forum | Fri May 15 18:13:35 EDT 1998 | Earl Moon
| | | Does the temp. profiles used to reflow double sided pcb's through a IR oven | | on FR4 board material have to be re-established if it is changed to | | polyimide? Boards will be baked out prior to assembly. | | any response would be most appr
Electronics Forum | Wed Oct 25 10:33:08 EDT 2000 | Chris
I need to know the advantages or disavantages of a plastic or FR4/Flex based BGA over the ceramic based BGA. We have a BGA package we are going to have produced. Some want to have it made out of ceramic because they feel a ceramic package will be a