Electronics Forum | Wed Jun 17 01:02:16 EDT 2015 | armandogomez
Hello Had a similar problem way back with the hydra, first go to the service program manually activate the hydra camera then move the Xwagon to place the hydra ref plate over the hydra camera and check first if the camera works, second the image you
Electronics Forum | Wed Mar 30 19:37:17 EDT 2022 | jzeivel
I have an MY200DX mycronic pick and place machine. I recently started getting this error "F-MOT-MOVENICE HYDRA Theta2/1295: Encoder Signal is noisy". Has anyone else ever had this error? The machine will still run, but this error will pop up rando
Electronics Forum | Sat Feb 22 09:41:44 EST 2020 | tomdegas
I am getting a F-MOT-MSEDYN HYDRA Z/156 error when I try to initialize Hardware on my My9. Interestingly though when I go into the "Service" program, I can initialize the Hydra Z with no problem. But when I try in TPSys, it doesn't pass and I get t
Electronics Forum | Mon Apr 18 18:23:41 EDT 2022 | youngbuck
Hello everyone, We have a Siemens HS50 error going on as soon as we boot up. It shows message saying "Machine is in test mode." Cause: Initalizing gantry axes. Start Sitest and check machine (firmwre versions,configuration, etc. It will try to refere
Electronics Forum | Thu Dec 09 04:11:54 EST 2021 | cirsol
Hello Forumers, I'm hoping there might be a SiPlace expert or two trawling the forum. We have an S25 machine that essentially has a failed MC harddrive and we're trying to rebuild a new one. Attached are a few images and perhaps something shown her
Electronics Forum | Sat May 29 14:03:18 EDT 2010 | padawanlinuxero
Hello guys! I have a problem I had to change the MI Board on a MYDATA TP9-4 machine because it was firing 3 or more feeders at the same time, after the change it run great but then for some reason after a while it start to show an error message that
Electronics Forum | Fri Sep 06 13:49:17 EDT 2002 | soupatech
Question: I am going to start placing 3mm x 3mm plastic smt leds and want the absolute lowest errors caused by the nozzle either dropping or allowing the part to shift. Would a 2.5mm nozzle be too big for the 3mm part. My logic is that the more surfa
Electronics Forum | Fri Oct 11 03:56:39 EDT 2019 | chrislandafont
Hi Tsvetan, Yes, I've heard it's difficult to program but good once it gets going. At the moment, I'm working through the manuals, but can't find a step by step guide, just lots of reference material on how to do things, but not knowing what orde
Electronics Forum | Tue Jan 05 17:12:20 EST 2021 | greezmky
Before our holiday shutdown an experienced party came in and showed me the PAM process on the IP-3. We made some adjustments, and all was well. Yesterday I found that we may have accidentally mixed up some nozzles, so I verified where each should go