Electronics Forum | Wed Nov 09 05:12:43 EST 2011 | bobpan
Motor error 4 is an error that is caused by the machine not reaching a position in a timely matter. Usually its in the x/y axis but also could be z. If you have cleared the mod codes (function 35 shift 7) the machine should home. Usually this problem
Electronics Forum | Mon Oct 31 23:34:30 EDT 2011 | haiae
Dear All, I bought a used Contact 3AVX some months before. The machine run seem be good until last week I meet a problem as follows: - Head one(Left side) does not pick up components (0805 only) any more after pick good about 10 components. Spindles
Electronics Forum | Thu Sep 14 18:10:12 EDT 2006 | SWAG
Good point Russ but we do builds that comprise of 50 of this and 100 of that. Our high average issue might be around 400 or 500 parts but most are under 100. 20,40,60 flat over-issue gets us set-up and error scrap. 2% of 50 is 1 part. 2% of 500
Electronics Forum | Tue Jul 29 17:59:53 EDT 2014 | guts1872
I have had to flush the ram when replacing a TEP controller. These are kind of scetchy instructions from my notes, never could get PPM to send me any procedures. Hope this helps. Plug keyboard and monitor into RT computer and navigate to 2kla/RT/TEP
Electronics Forum | Fri Sep 14 10:53:25 EDT 2012 | mili
In Setup menu there is a last option Debug. Debug choosing a window with Rack0, Rack1, Rack2, Rack3, log RS485 opens. Choosing rack0 a window with parameters S3 boxes 1 to 12 Input and certain boxes are checked, S4 Output from 1-8, from 1-8 S5 Outpu
Electronics Forum | Thu Sep 22 18:47:08 EDT 2011 | rodrigo
Hi all, We just got this machine and it is not fully functional. I read somewhere here that the folder mint has some useful stuff. I run mint and it said that it cannot communicate with card 0,1,2,3 (x1,x2,x3,x4). It said to make sure the cards are
Electronics Forum | Thu Aug 12 14:55:08 EDT 2004 | johnw
Hi guys I havnt been on for a while so its nice to be back been working in europe mostly Fuji CP6 skewing rnets Marcels comment is the closest rnets are a problem as said before the main areas are 1 A good assmbley shape is a must with 30% defaul
Electronics Forum | Sat Sep 26 14:54:52 EDT 2015 | ercdave1
Hello, just a quick update on this issue. I disabled head 2 on beam 2 which was the second head I worked on, and left only active the head that I had work with first and ran dry cycle with. after disabling the head 2, the machine zeroed with no pr
Electronics Forum | Thu Nov 18 15:07:27 EST 2004 | valuems
Hello Boy this sure brings back memories from the years past. Was a field engineer for universal for about 9 years. Worked almost exclusively on the Rad 1 and Rad 2. The first thing that I would do is remove the sequencer head that fires at the sa
Electronics Forum | Wed Jan 23 12:35:24 EST 2008 | bobpan
Here is a few things to try.... 1. Spin the z-shaft with your fingers and make sure it is smooth and easy to turn. 2. Check your handling in your profile for the part that the software is locking up on.......You cannot go any slower than 40% or this
.png)
