Electronics Forum | Fri Aug 01 08:15:49 EDT 2014 | kurtiss
Thank you, Kurtis
Electronics Forum | Fri Aug 01 12:04:54 EDT 2014 | jimmyboz
That's great.
Electronics Forum | Fri Oct 15 16:52:52 EDT 2010 | wingding
Fuji IP2: I am having problems with an MTU Cycle Alarm error. There is no such error listed in the IP2 manual or the MTU manual. It sometimes comes up while placing parts on a board or sometimes right after Zero Set. Does anyone know what generates t
Electronics Forum | Sat Jul 26 12:37:10 EDT 2014 | jimmyboz
In the future, please try to explain the situation with some detail. Usually this is the sensor on the 10th station to verify to nozzles are in the up position.
Electronics Forum | Thu Sep 15 15:17:21 EDT 2005 | GAK
What kind of error code do you get? Check your sensers my be bad.
Electronics Forum | Thu Sep 15 16:02:20 EDT 2005 | jdengler
Over Current means the motor is drawling too much current. Check for a jam on that axis, bad wire, bad motor, bad servo amp (yes the amp can go bad and make it appear that the motor is drawling too much current). Jerry
Electronics Forum | Thu Sep 15 18:02:52 EDT 2005 | GAK
If the end sensor is bad it will cause the axis to past it and travel against the end stop and cause an over current also. So it kind of depends on what the machine is trying to do.
Electronics Forum | Fri Sep 16 08:36:45 EDT 2005 | ajay
check some relay might be bad on MTU. we faced similar problem in IP3.
Electronics Forum | Thu Nov 04 06:46:19 EDT 2010 | adriana
We find the problem on Servo Pack for F theta axis .The component QM20TD-H Mediu power Switching is damaged! Many thanks!
Electronics Forum | Fri Oct 23 10:21:45 EDT 2015 | kurtiss
During production the machine Cycle Alarm ESC 3. When cycling power the error shows up again during a zero set after performing the Z1 zero set. When it errors out on zero set the only option that the machine allows is to power off. Thanks in advance
