Electronics Forum | Wed Oct 19 15:55:51 EDT 2011 | paola
Does anyone know how to comply with the requirement on conflict minerals being an electronic component distributor?
Electronics Forum | Sun Oct 23 14:22:11 EDT 2011 | davef
Here's what we know: http://www.ipc.org/ContentPage.aspx?pageid=Conflict-Minerals
Electronics Forum | Mon Oct 24 18:05:24 EDT 2011 | paola
One of our customer had request for us to comply with the law and to retrieve information from our supply chain for the compliance . We are just electronic distributors, as the QM I need to request the resources necessaries to flow down the requireme
Electronics Forum | Mon Mar 20 22:33:08 EST 2000 | RJJOHNSON
Cim system is what we used on cp6 d axis tables.It worked very well.I liked it and it was for pre run and during run feeder feeding.Uses a barcode reader and reads bottom of d axis where barcode are to match what is assigned to a slot by pre scanning
Electronics Forum | Mon Mar 20 22:33:08 EST 2000 | RJJOHNSON
Cim system is what we used on cp6 d axis tables.It worked very well.I liked it and it was for pre run and during run feeder feeding.Uses a barcode reader and reads bottom of d axis where barcode are to match what is assigned to a slot by pre scanning
Electronics Forum | Wed Mar 09 07:44:32 EST 2005 | cyber_wolf
Ya know, The weird part is that we seem to have a real bad rash of nozzle sticking right after windmill PM's. After the machine runs for a week or so it seems to get way better. Like 99 to 100 % better. This leads me to believe that it is not a Z h
Electronics Forum | Tue Jan 31 11:57:40 EST 2006 | aj
i would agree with taking a closer look at the fiducials. I have the same line config. here but have to say that I have never experienced any conflict between machines. One thing I have seen before is when we ran a particular product on the machine
Electronics Forum | Mon Mar 10 14:13:36 EST 2003 | msivigny
Hello Bill, As I mentioned in an earlier thread, I was not familiar with the PAM system but have since been given a quick run down on how it performs its measurement routine. It is an acceptable way to measure and optimze Fuji chip shooter performanc
Electronics Forum | Fri Sep 22 11:52:47 EDT 2006 | basem
Then Fuji it is. I'm happy with the features the Juki's R seriers are giving out. It is like, everything I could think of a placement machine if I would design one for myself...the 2060R is something I would buy happily...especially after you telling
Electronics Forum | Fri Mar 03 07:03:57 EST 2006 | Mity-C
Good Morning All, We have a Mydata shop. 5 lines in all. We are also using a mix of old style and Agilis feeders. The claim that you will not loose parts in loading is based on keeping the clip with the reel. This is the whole basis of the Agilis co
