Electronics Forum | Wed Jun 29 19:33:12 EDT 2005 | matjen
After the machine stops for any reason when restarted the z table goes to loader position comes up then goes back down and re-reads the fiducials, only one machine does this but we are losing valuable cycle time after every part change. We have Fuji
Electronics Forum | Thu Apr 12 15:21:12 EDT 2012 | jdengler
Have you tried to do a reset start? When Fuji's act weird the first place to start is a reset start, then re-load the Proper Status and Program. Jerry
Electronics Forum | Mon Jan 21 11:28:28 EST 2013 | dhopps
The machine will have to be reset-started to wipe the current proper and status out of the machine before you can communicate with an MCS. This can be dangerous if you do not have a current paper copy or disk back-up of your proper because you will
Electronics Forum | Mon Jul 28 19:03:53 EDT 2003 | Ryan Liao
Hi mantis, Thank you for your helps. I had checked the CP7 error code index application. It also gives me the same answer. It tell me " the part pickup status is bad" and I have to "Make sure that the nozzle is not bent and that the part is being pro
Electronics Forum | Fri Jun 22 13:49:27 EDT 2012 | johndoe0222
We recently made a backup of our FujiFlexa and Fuji give us a new License for the new installation. Then loaded the program into the machine and now its placing some of the components off. We retransmitted the Status and Proper then reloaded the
Electronics Forum | Wed Jan 19 10:44:23 EST 2005 | russ
Although I have not personally run or programmed either the Universal or the Fuji to any great extent, I have worked in factories that have utilized each type. One had 4796 machines and the other used Fuji CP3, 4, 4-2, 6, 643. As an observer I am d
Electronics Forum | Tue Jun 16 20:37:11 EDT 1998 | Ben Salisbury
heh... I've run into an unusual problem with my CP2. I am able to pull up all the productiona data off the machine except for the qty of parts errored or junked. I've already compared all the proper data with a function CP2 and everything matches up
Electronics Forum | Thu Jun 10 16:23:11 EDT 2004 | davem
Hi Grant, In previous positions I've had experience with the Fuji CP43, CP6, CP642, CP643, CP65, IP3 & QP242. In operating, training and process engineering capacities. Presently, I'm working with 2 SMT lines (in a process engineering capacity) wit
Electronics Forum | Thu Jun 24 07:22:19 EDT 2004 | cyber_wolf
I know I have posed this question before, but I would like to open this discussion again. We do several change overs through the course of three shifts on our CP642 line. When we start a new job, we have tons of tape feeder overlay problems.(The over
Career Center | garaden grove, California USA | Engineering,Management,Production,Quality Control,Technical Support
11 years experience in SMT process.
