Electronics Forum | Sat Dec 12 12:25:14 EST 1998 | David Lombard
| My Fuji IP3 keeps getting the Check Sensor Error. | What is the problem? | This problem is caused by either of two things. First the vacuum chuck get dirty and needs to be cleaned "PM". If the problem is persistant the vacuum chick has worn down
Electronics Forum | Sat Dec 12 12:26:08 EST 1998 | David Lombard
| My Fuji IP3 keeps getting the Check Sensor Error. | What is the problem? | This problem is caused by either of two things. First the vacuum chuck get dirty and needs to be cleaned "PM". If the problem is persistant the vacuum chick has worn down
Electronics Forum | Mon Dec 18 21:23:13 EST 2006 | jgarver1
The spline shaft is bent. I have replaced a number of these over the years with the exact same symptoms. How is your placement? Your 180 degree placements should be skewed if the shaft is bent. 0 Degree placements are typically acceptable due to
Electronics Forum | Fri Jun 14 13:19:15 EDT 2002 | mjabure
The first question is, is this a high mix, low volume environment or vice versa? If it's the former then Kens solution is something you might want to look into. Depending on your feeder set up you might check to see if your operators have been traine
Electronics Forum | Tue Aug 22 16:33:59 EDT 2006 | aj
I have also seen this error on the machine and it was related to a dodgy PD. aj...
Electronics Forum | Thu Jun 10 13:41:59 EDT 2010 | cyber_wolf
The transformer was probably wired wrong and you done blowed ol bessie up.
Electronics Forum | Wed Jun 09 10:41:28 EDT 2010 | chrislyttle
We've been having some problems with out Fuji IP2E machine that we've recently bought from a company that is no longer operating here. Since installing it we've encountered a few problems with it starting up. To give you a quick breakdown of its be
Electronics Forum | Fri Mar 08 12:22:18 EST 2002 | pr
Have you contacted Fuji? I believe we had the same situation a while back and (I think) it was a proper setting and not a sensor problem. A tech. can probably walk you through it over the phone. good luck, pr
Electronics Forum | Wed Aug 23 14:44:07 EDT 2006 | johnw
They are various way to debug this problem, try booting into mecha check, The cpu wouldnt cause a vp error all that is related to the VP are 3 cards the gognex the vp card and the memry backup card. If this fails print out the trace machine code and
Electronics Forum | Sun Aug 20 02:31:18 EDT 2006 | daxman
Last week, when we turned on our IP3, we received an error on our IP3, which read "Fatal Error with VP Turn Power Off" We had been running product the day before, and the day after we received this error. The function keys are locked and will not w
.png)
