Used SMT Equipment | SMT Equipment
Product name: KE – 3010ACL high-speed chip mounter Acl. Product code: KE - 3010 Detailed product introduction Characteristic： Constantly improve the KE series products. So as to realize the high speed high quality electric production line of f
Used SMT Equipment | SMT Equipment
Product name: RX - 6 high-speed module chip mounter Product number: RX - 6 Detailed product introduction Characteristic： With high productivity, versatility, high quality new modular placement machine RX - 6 listed Draw/monitor corresponding p
Parts & Supplies | Assembly Accessories
HELLER OVEN 1809A REPLACEMENT PARTS CHEON BOK CAPACITOR RUN INDUCTION MOTOR CBM-9230 CP6383 Specifications: Brand Name HELLER 1809A MOTOR Part number CBM-9230 Model CP6383 Ensure Test in machine before shipping Guarantee Original 100
Technical Library | 2019-06-21 10:39:15.0
Recently, an ACI Technologies (ACI) customer called to discuss failures that they had observed with some through-hole capacitor parts. The components were experiencing failures following vibration and accelerated stress testing. Upon receipt of the samples, ACI performed three levels of inspection and Energy Dispersive Spectroscopy (EDS) testing to investigate the root cause of the failures. These analyses enabled ACI to verify the elements comprising the solder joints and make the following recommendations in order to prevent future occurrences. The first inspection was to investigate the capacitor leads using optical microscopy, and no anomalies were found that could indicate bad parts from the vendor or improper handling prior to assembly. However, vertical fill in the barrel of the plated through-holes was too close to the IPC-A-610 minimum specification of 75% to determine a pass/fail condition, and therefore required further investigation.
Parts & Supplies | Pick and Place/Feeders
PANASONIC NOZZLE CHANGER (MULTI FUNCTIONAL HEADS)..KXFX036XA00 1.Quality and package:Each part is checked and tested strictly by our professional QC, make sure each product is in good quality and working condition. Meanwhile each package would be w
Parts & Supplies | Assembly Accessories
TEST PCB LP3 ..00359534-01 Tester PEL-2002A Push pull tester NK-500 Neon lamp tester SX-C Test Probes (Universal Probe) TL20 Probes Connector Test Point temp (Male) SMPW-K-M. DIP TESTER DS-10
Parts & Supplies | Assembly Accessories
TEST PCB LP3 ..00359534-01 Tester PEL-2002A Push pull tester NK-500 Neon lamp tester SX-C Test Probes (Universal Probe) TL20 Probes Connector Test Point temp (Male) SMPW-K-M. DIP TESTER DS-10
Parts & Supplies | Pick and Place/Feeders
Base size Max 410 × 360mm Min 50 × 30mm Smudge speed 0.1 seconds / launch(best conditions) Smudge accuracy ± 0.15 mm Needle type 30cc Set the smear angle 0 ° ~ 359 °(1 ° unit) A redesigned dot head. The standard
LISA SPIDER robot pick and place machine 2D/3D vision components copanarity check Tape & reel for tape OUT process Tray stacker for Tray IN proce/OUT process Tape IN feeder Anyfeeder for loose component sorting More under www.aatec.ch
Technical Library | 2019-05-29 10:40:59.0
Design for Test or Design for Testability (DFT) can best be described as the techniques utilized to add testability features to an electronic hardware product design. These added features make it easier to develop and apply manufacturing tests to assure that the product functions correctly.
.png)
